Kappa carbide precipitation in duplex Fe-Al-Mn-Ni-C low-density steel

Burja, Jaka (avtor), Šetina Batič, Barbara (avtor), Balaško, Tilen (avtor)

The microstructural evolution of a Fe-Mn-Al-Ni-C low-density steel was studied. The lightweight low-density steels are a promising material for the transportation industry, due to their good mechanical properties and low density. The base microstructure of the investigated steel consists of ferrite and austenite. Thermo-Calc calculations showed the formation of an ordered BCC (body-centred cubic) B2 phase below 1181 °C and kappa carbides below 864 °C. The steel was produced in a vacuum induction furnace, cast into ingots and hot forged into bars. The forged bars were solution annealed and then isothermally annealed at 350, 450, 550, 650, 750, and 850 °C. The microstructure of the as-cast state, the hot forged state, solution annealed, and isothermally annealed were investigated by optical microscopy and scanning electron microscopy. The results showed the formation of kappa carbides and the ordered B2 phase. The kappa carbides appeared in the as-cast sample and at the grain boundaries of the isothermally annealed samples. At 550 °C, the kappa carbides began to form in the austenite phase and coarsened with increasing temperature.

• Jezik: Angleški jezik
• Ključne besede: duplex steel, low-density steel, precipitation, kappa carbides
• Vrsta gradiva: Članek v reviji
• Tipologija: 1.01 - Izvirni znanstveni članek
• Organizacija: NTF - Naravoslovnotehniška fakulteta
• Status publikacije: Objavljeno
• Različica publikacije: Objavljena publikacija
• Leto izida: 2021
• Št. strani: 11 str.
• Številčenje: Vol. 11, iss. 10, art. 1261
• PID: 20.500.12556/RUL-136226
• UDK: 620.1:67.017:669.1
• ISSN pri članku: 2073-4352
• DOI: 10.3390/cryst11101261
• COBISS.SI-ID: 81738755
• Datum objave v RUL: 20.04.2022

Gradivo je del revije

• Naslov: Crystals
• Skrajšan naslov: Crystals
• Založnik: MDPI
• ISSN: 2073-4352
• COBISS.SI-ID: 36677893

Licence

• Licenca: CC BY 4.0, Creative Commons Priznanje avtorstva 4.0 Mednarodna
• Povezava: http://creativecommons.org/licenses/by/4.0/deed.sl
• Opis: To je standardna licenca Creative Commons, ki daje uporabnikom največ možnosti za nadaljnjo uporabo dela, pri čemer morajo navesti avtorja.
• Začetek licenciranja: 18.10.2021

Projekti

• Financer: ARRS - Agencija za raziskovalno dejavnost Republike Slovenije
• Številka projekta: P2-0050
• Naslov: Kovinski materiali in tehnologije