Vodotesnost rotorja, izdelanega z dvokomponentnim injekcijskim brizganjem

Kavčič, Klemen (avtor), Slemenik Perše, Lidija (mentor)

V sklopu magistrskega dela smo raziskovali kvaliteto spoja dvokomponentnega injekcijskega brizganja termoplasta polifenilen sulfida, ki nastane pri izdelavi rotorja. Zunanjost rotorja je tekom delovanja izpostavljena vodi. Pri tem pa je pomembno, da zagotovimo dober spoj med obema brizganima komponentama, saj bi prisotnost vode v rotorju poslabšala elektromagnetne lastnosti rotorja. V sklopu naloge smo najprej preverili mehanske lastnosti spoja obeh komponent na testnih epruvetah, ki so bile izdelane pri različnih izdelovalnih pogojih. Sledila je izdelava rotorjev z dvokomponentnim brizganjem in njihovo testiranje. Kvaliteta spoja je bila ocenjena na dva načina: s testiranjem mehanske trdnosti spoja rotorja in testom puščanja helija. Na podlagi testov je bilo ugotovljeno, da sta za dobro mehansko spojitev obeh komponent pomembna čas ciklusa ter temperatura druge komponente brizganja.

• Jezik: Slovenski jezik
• Ključne besede: dvokomponentno injekcijsko brizganje tesnjenje spoja rotor mehanske lastnosti preverjanje puščanja
• Vrsta gradiva: Magistrsko delo/naloga
• Tipologija: 2.09 - Magistrsko delo
• Organizacija: FS - Fakulteta za strojništvo
• Kraj izida: Ljubljana
• Založnik: [K. Kavčič]
• Leto izida: 2018
• Št. strani: XXII, 66 str.
• PID: 20.500.12556/RUL-101678
• UDK: 621.9:678.027.74:62-253(043.2)
• COBISS.SI-ID: 16133659
• Datum objave v RUL: 24.06.2018

Sekundarni jezik

• Jezik: Angleški jezik
• Naslov: Rotor watertightness made with two-component injection moulding

Izvleček

Within the master thesis we investigate the quality of the joint between two materials of the two-component injection moulding used for the manufacturing of rotors and made from thermoplastic polyphenylene sulphide. The exterior of the rotor is exposed to water during its operation. That is why, it is important to ensure a good connection between the two injected components, since the presence of the water in the rotor will deteriorate the electromagnetic properties of the rotor. Within the thesis, we first checked the mechanical properties of the joints between the two components on the test samples, that were produced under different manufacturing conditions. This was followed by the production of the rotor with two-component injection moulding and its testing. The quality of the joint on the rotor was assessed in two ways: by testing the mechanical strength of the rotor joint and the helium leak test. Based on the tests, it was found that for good mechanical coupling of both components, manufacturing cycle time and the temperature of the second injection component are important.

• Ključne besede: two-component injection moulding Watertightness of a joint rotor mechanical properties leakage testing