Injection molding simulation with solid semi-crystalline polymer mechanical behavior for ejection analysis

Mole, Nikolaj (avtor), Krebelj, Kristjan (avtor), Štok, Boris (avtor)

Injection molded products, produced from semi-crystalline polymers may include undercut features which can introduce distortion to the shape of the product during ejection. A thermo-mechanical modeling approach for simulating these advanced ejection problems is developed. The approach is formed by combining a method for three-dimensional residual stress prediction and an advanced material model for modeling the solid visco-elasto-plastic mechanical behavior. The task of this work is to assess, by analyzing a plaque-like product, the performance of the approach in the absence of the distortive ejection effects. The numerically predicted product shrinkage and mass at different packing pressure settings are compared to experimental results. The effect of packing pressure on product shrinkage and mass was reproduced by the model and the final residual stress field was found to be in accordance with the expectations. This confirms that the methodology could be used to analyze advanced ejection problems.

• Jezik: Angleški jezik
• Ključne besede: injection molding, numerical simulation, residual stresses, shrinkage, ejection
• Vrsta gradiva: Delo ni kategorizirano
• Tipologija: 1.01 - Izvirni znanstveni članek
• Organizacija: FS - Fakulteta za strojništvo
• Različica publikacije: Recenzirani rokopis
• Št. strani: 4111-4124
• Številčenje: 93, 9
• PID: 20.500.12556/RUL-98332
• UDK: 519.62:678.027.74
• DOI: 10.1007/s00170-017-0847-3
• Datum objave v RUL: 28.02.2018

Gradivo je del revije

• Naslov: the international journal of advanced manufacturing technology
• ISSN: 0268-3768