Možnost uporabe stereolitografije v serijski proizvodnji

Laure, Dejan (avtor), Lebar, Andrej (mentor), Orbanić, Henri (komentor)

V teoretično usmerjeni zaključni nalogi smo preverjali, kakšne so možnosti, da stereolitografijo uporabimo kot izdelovalno tehnologijo v serijski proizvodnji. Zaradi slabših izdelovalnih časov je dolgo veljalo, da aditivne tehnologije niso primerne za izdelavo končnih produktov in so se večinsko uporabljale zgolj za tiskanje prototipov. Ekonomičnost uporabe stereolitografije in novo razvite tehnologije CLIP v proizvodnji smo analizirali na realnem primeru tiskanja lupin slušnih aparatov. Ugotovili smo, da sta lahko obe tehnologiji uspešno uporabljeni v neposredni digitalni proizvodnji, v kolikor je proces pravilno optimiziran.

• Jezik: Slovenski jezik
• Ključne besede: stereolitografija, prototipiranje, neposredna digitalna proizvodnja, aditivne proizvodne tehnologije, CLIP
• Vrsta gradiva: Diplomsko delo/naloga
• Organizacija: FS - Fakulteta za strojništvo
• Leto izida: 2017
• PID: 20.500.12556/RUL-94953
• Datum objave v RUL: 11.09.2017

Sekundarni jezik

• Jezik: Angleški jezik
• Naslov: The possibility of stereolithography use in serial production

Izvleček

In the theoretically orientated bachelor's thesis we examined the possibilities of using stereolithography as production technology in serial production. Due to long manufacturing times, it has long been considered that additive manufacturing technologies are not suitable for the production of finished products and were mostly used only for printing prototypes. The economic analysis of using stereolithography and the newly developed CLIP technology in production was based on the case of hearing aid shells. Our research has shown that both technologies can be successfully used in direct digital production if the process is properly optimized.

• Ključne besede: stereolithography, prototyping, direct digital manufacturing, additive manufacturing, CLIP