Pomožni električni pogon za snežno desko

LUSAVEC, BLAŽ (avtor), Vončina, Danijel (mentor)

Za cilj diplomske naloge sem si zadal izdelavo baterijsko napajane in brezžično upravljane naprave, ki nudi pogon rekreativnim deskarjem na snegu na ravninskih predelih urejenih smučarskih prog. Napravo z daljinskim upravljalnikom po potrebi vklopimo; ta aktivira postavitev pogonske gosenice v delovni položaj, jo zažene in potisne deskarja naprej. Ko pogon ni več potreben, se gosenica pospravi nazaj v prvotni položaj, kjer deskarja ne ovira. Za takšno napravo je ključnega pomena, da je minimalnih potrebnih dimenzij, saj smo omejeni na prostor med vezmi snežne deske in njeno širino, hkrati pa mora imeti čim boljši kontakt s snežno površino za zagotavljanje učinkovitega pogona. Biti mora tudi nizka in lahka, da deskarju ni v napoto in mu ne predstavlja dodatne ovire. Osnovne komponente takšne naprave so: elektromotor, reduktor, krmilna elektronika z možnostjo brezžičnega upravljanja, akumulator in pogonska gosenica. Iz varnostnih razlogov morajo biti električne komponente zaščitene pred stikom z vodo. Poleg prototipne naprave je v diplomskem delu predstavljenih tudi nekaj idej, kako bi bilo samo napravo možno nadgraditi in izboljšati, saj bi bilo za izdelavo izboljšane različice potrebnega veliko več časa in pa denarja, kot ju imam trenutno na razpolag

• Jezik: Slovenski jezik
• Ključne besede: snežna deska, ravnina, električni pogon, gosenica
• Vrsta gradiva: Diplomsko delo
• Organizacija: FE - Fakulteta za elektrotehniko
• Leto izida: 2016
• PID: 20.500.12556/RUL-83792
• Datum objave v RUL: 30.06.2016

Sekundarni jezik

• Jezik: Angleški jezik
• Naslov: Assisted electric drive for snowboard

Izvleček

The aim of my thesis was to construct a battery-powered, wirelessly controlled device that provides propulsion for recreational snowboarders on level ground parts of marked ski slopes. The device can be switched on by a remote control when needed, which then activates the caterpillar tracks to shift into drive mode, starts the motor and drives the snowboarder forward. Once the motor is no longer needed, the caterpillar tracks are stowed back into their initial position where they do not obstruct the snowboarder. It is essential for this type of device to be of minimal size, since it is restricted to fit into the space between the snowboard bindings and the edge of the snowboard's width, while at the same time it must maintain optimal contact with the snow-covered surface for the drive to be efficient. The device must also be low-lying and lightweight as not to hinder the snowboarder. The basic components of the device are: electric motor, gearbox, control electronics operated wirelessly, battery and caterpillar drive. For safety reasons, the electric components must be protected from coming into contact with water. In addition to the prototype, the thesis also introduces several new ideas for upgrading the device and improving its quality, since the time and means required to produce a better version of the device were limited.

• Ključne besede: snowboard, level ground, electric drive, caterpillar