Effect of moisture content, surface preparation and lamellae orientation on Mode II strain energy release rate of polyurethane-bonded beech wood

Capuder, Martin (avtor), Azinović, Boris (avtor), Merhar, Miran (avtor), Straže, Aleš (avtor)

Understanding the Mode II fracture behavior of adhesive joints in hardwood species is essential for reliable structural design in timber engineering. This study investigates the shear fracture energy (GII) of polyurethane (PUR)-bonded European beech wood (Fagus sylvatica L.) under two different moisture contents. Three-point bending end-notched flexure (3ENF) tests were conducted on bonded specimens conditioned at 12% and 18% moisture content (MC), with three types of bonding surface preparation: planed, planed + sanded, planed + primer prior to bonding. Crack initiation and propagation were monitored using 3D digital image correlation (DIC) and fracture energy was calculated using the compliance-based beam method (CBBM). The results reveal a clear influence of both moisture content and surface treatment on Mode II fracture behavior. Higher moisture content consistently reduced Gc and stress values, while specimens with different lamellae orientations achieved the highest stresses before adhesive joint failure occurred. Different bond failures and their influence on fracture behavior are also discussed. The critical Mode II strain energy release rate, GIIc, was defined at the maximum applied load corresponding to the onset of unstable crack propagation, as confirmed by synchronized DIC measurements. The findings contribute to an improved understanding of shear behavior in PUR-bonded hardwood joints and offer valuable input for cohesive zone modelling and structural performance prediction.

• Jezik: Angleški jezik
• Ključne besede: wood, adhesive bond, fracture mode II, digital image correlation, fracture energy
• Vrsta gradiva: Članek v reviji
• Tipologija: 1.01 - Izvirni znanstveni članek
• Organizacija: BF - Biotehniška fakulteta
• Status publikacije: Objavljeno
• Različica publikacije: Objavljena publikacija
• Datum objave: 01.01.2026
• Leto izida: 2026
• Št. strani: 16 str.
• Številčenje: iss. 4, Vol. 84
• PID: 20.500.12556/RUL-185153
• UDK: 630*843
• ISSN pri članku: 1436-736X
• DOI: 10.1007/s00107-026-02447-9
• COBISS.SI-ID: 285986051
• Patent: https://repozitorij.uni-lj.si/admin/GradivoOsnovno.php?id=185153
• Datum objave v RUL: 24.07.2026

Gradivo je del revije

• Naslov: European journal of wood and wood products
• Založnik: Springer
• ISSN: 1436-736X
• COBISS.SI-ID: 22253061

Licence

• Licenca: CC BY-NC 4.0, Creative Commons Priznanje avtorstva-Nekomercialno 4.0 Mednarodna
• Povezava: http://creativecommons.org/licenses/by-nc/4.0/deed.sl
• Opis: Licenca Creative Commons, ki prepoveduje komercialno uporabo, vendar uporabniki ne rabijo upravljati materialnih avtorskih pravic na izpeljanih delih z enako licenco.

Sekundarni jezik

• Jezik: Slovenski jezik
• Ključne besede: les, lepilni spoj, lomni način II, digitalna korelacija slik, lomna energija