Podrobno

Optimizing lubrication in step slider bearings : the role of oiliness additives on film formation and friction reduction
ID Jing, Zhaogang (Avtor), ID Dong, Haoyu (Avtor), ID Jin, Wei (Avtor), ID Guo, Feng (Avtor), ID Kalin, Mitjan (Avtor), ID Li, Ziying (Avtor), ID Wang, Dong (Avtor), ID Ju, Chao (Avtor)

.pdfPDF - Predstavitvena datoteka, prenos (989,16 KB)
MD5: CFBB273BAD9D15B94FAF5B766AF8A1FC
URLURL - Izvorni URL, za dostop obiščite https://www.sciencedirect.com/science/article/pii/S0301679X26004779 Povezava se odpre v novem oknu

Izvleček
This study examines how the molecular structures of oiliness additives affect the lubrication performance of a step slider bearing. Here an optical step-slider-on-disc tribometer was used to measure interferometric film thickness together with friction force under the present test conditions. Seven representative molecules (undecanedioic acid, undecanoic acid, palmitic acid, stearic acid, oleic acid, oleylamine and oleyl alcohol) were each blended into PAO8 at 0.15 wt% to separately probe headgroup polarity, alkyl-chain length, saturation and the number of polar heads. Compared with neat PAO8, every formulation produced a thicker film (up to 106% increase) and a lower coefficient of friction (up to 65.9% reduction), with stearic acid delivering the best overall improvement. To interpret the trends, wettability of the step-slider surface after lubricant treatment was assessed by deionized-water contact-angle measurements. The observed inlet–outlet wetting asymmetry is consistent with a possible asymmetry in interfacial slip, which may contribute to the experimentally observed combination of film-thickness increase and friction reduction.

Jezik:Angleški jezik
Ključne besede:oiliness additives, surface adsorption films, step slider bearing, optical interferometry, film thickness, interfacial slip
Vrsta gradiva:Članek v reviji
Tipologija:1.01 - Izvirni znanstveni članek
Organizacija:FS - Fakulteta za strojništvo
Status publikacije:Objavljeno
Različica publikacije:Recenzirani rokopis
Leto izida:2026
Št. strani:Str. 1-10
Številčenje:Vol. 222, art. 112134
PID:20.500.12556/RUL-183418 Povezava se odpre v novem oknu
UDK:539.92:539.37:669.14
ISSN pri članku:0301-679X
DOI:10.1016/j.triboint.2026.112134 Povezava se odpre v novem oknu
COBISS.SI-ID:278637315 Povezava se odpre v novem oknu
Datum objave v RUL:12.06.2026
Število ogledov:231
Število prenosov:229
Metapodatki:XML DC-XML DC-RDF
:
Kopiraj citat
Objavi na:Bookmark and Share

Gradivo je del revije

Naslov:Tribology international
Skrajšan naslov:Tribol. int.
Založnik:Elsevier
ISSN:0301-679X
COBISS.SI-ID:26558976 Povezava se odpre v novem oknu

Licence

Licenca:CC BY-NC-ND 4.0, Creative Commons Priznanje avtorstva-Nekomercialno-Brez predelav 4.0 Mednarodna
Povezava:http://creativecommons.org/licenses/by-nc-nd/4.0/deed.sl
Opis:Najbolj omejujoča licenca Creative Commons. Uporabniki lahko prenesejo in delijo delo v nekomercialne namene in ga ne smejo uporabiti za nobene druge namene.

Sekundarni jezik

Jezik:Slovenski jezik
Ključne besede:eksperiment z aspernostjo na terenu, večaspernostni stiki, realna kontaktna površina, utrjevanje, deformacija, jeklo, hrapavost

Projekti

Financer:Drugi - Drug financer ali več financerjev
Program financ.:Postdoctoral Innovation Program of Shandong Province
Številka projekta:SDCX-ZG-202502062

Financer:National Natural Science Foundation of China
Številka projekta:52575217

Financer:Drugi - Drug financer ali več financerjev
Program financ.:Key Project of Shandong Bearing Intelligent Manufacturing Community
Številka projekta:gjgxjs002

Podobna dela

Podobna dela v RUL:
Podobna dela v drugih slovenskih zbirkah:

Nazaj