Vaš brskalnik ne omogoča JavaScript!
JavaScript je nujen za pravilno delovanje teh spletnih strani. Omogočite JavaScript ali pa uporabite sodobnejši brskalnik.
Repozitorij Univerze v Ljubljani
Nacionalni portal odprte znanosti
Odprta znanost
DiKUL
slv
|
eng
Iskanje
Napredno
Novo v RUL
Kaj je RUL
V številkah
Pomoč
Prijava
Podrobno
Analytical and numerical modelling of trapped air pockets in hydraulic pipeline systems
ID
Pekolj, Jošt
(
Avtor
),
ID
Bergant, Anton
(
Avtor
),
ID
Perpar, Matjaž
(
Avtor
),
ID
Ješe, Uroš
(
Avtor
)
PDF - Predstavitvena datoteka,
prenos
(1,29 MB)
MD5: 7F2C0BCD9C5344C79A6DB45F0D675618
URL - Izvorni URL, za dostop obiščite
https://iopscience.iop.org/article/10.1088/1755-1315/1483/1/012018/pdf
Galerija slik
Izvleček
During the operation of water-filled pipelines, air can get trapped in the primary water flow in the form of air trapped pockets or moving bubbles. Consequently, entrained air may change the liquid-filled-pipeline system’s transient response significantly. It could have either a beneficial or a detrimental effect on pressure oscillations. The effect is dependent on the spatial dimensions and other physical properties of the pipeline system, the amount, the location of the air pocket(s), and the nature of the transient excitation. This paper provides an overview of modeling the rigid and elastic water columns in a hydraulic pipeline system with an entrapped air pocket. It presents one-dimensional analytical and numerical solutions for the transient filling of the pipeline system, with the numerical model based on the method of characteristics (MOC).The research aims to analyse the effects of water column elasticity under varying system parameters. Simulation results indicate that higher air pocket pressures are achieved in the rigid column model and that the effects of water column elasticity are most pronounced with a small air length ratio and a high initial pressure difference between the reservoir and the air pocket.
Jezik:
Angleški jezik
Ključne besede:
water hammer
,
pipelines
,
trapped air pocket
,
analytical solutions
,
methods of characteristics
Vrsta gradiva:
Članek v reviji
Tipologija:
1.08 - Objavljeni znanstveni prispevek na konferenci
Organizacija:
FS - Fakulteta za strojništvo
Status publikacije:
Objavljeno
Različica publikacije:
Objavljena publikacija
Leto izida:
2025
Št. strani:
Str. 1-6
Številčenje:
Vol. 1483
PID:
20.500.12556/RUL-170659
UDK:
621.22:621.64
ISSN pri članku:
1755-1315
DOI:
10.1088/1755-1315/1483/1/012018
COBISS.SI-ID:
242317827
Datum objave v RUL:
11.07.2025
Število ogledov:
273
Število prenosov:
60
Metapodatki:
Citiraj gradivo
Navadno besedilo
BibTeX
EndNote XML
EndNote/Refer
RIS
ABNT
ACM Ref
AMA
APA
Chicago 17th Author-Date
Harvard
IEEE
ISO 690
MLA
Vancouver
:
Kopiraj citat
Objavi na:
Gradivo je del zbornika
Naslov:
9th IAHR meeting of the workgroup on cavitation and dynamic problems in hydraulic machinery and systems
COBISS.SI-ID:
242309891
Gradivo je del revije
Naslov:
IOP Conference Series : Earth and Environmental Science
Založnik:
Institute of Physics
ISSN:
1755-1315
COBISS.SI-ID:
4403041
Licence
Licenca:
CC BY 4.0, Creative Commons Priznanje avtorstva 4.0 Mednarodna
Povezava:
http://creativecommons.org/licenses/by/4.0/deed.sl
Opis:
To je standardna licenca Creative Commons, ki daje uporabnikom največ možnosti za nadaljnjo uporabo dela, pri čemer morajo navesti avtorja.
Sekundarni jezik
Jezik:
Slovenski jezik
Ključne besede:
vodni udar
,
cevovodi
,
ujet zračni mehur
,
analitične rešitve
,
metoda karakteristik
Projekti
Financer:
ARRS - Agencija za raziskovalno dejavnost Republike Slovenije
Številka projekta:
L2-1825
Naslov:
Modeliranje zračnih mehurjev ujetih v hidravličnih cevnih sistemih
Podobna dela
Podobna dela v RUL:
Podobna dela v drugih slovenskih zbirkah:
Nazaj