Thermoelasticity of injection-molded parts

Turk, Janez (avtor), Svenšek, Daniel (avtor)

In the realm of injection-molded parts, small length scale deformation defects such as sink marks often pose a major challenge to the aesthetics or functionality of the parts. To address this problem, we present a comprehensive thermoelastomechanical approach that calculates the deformation of injection molded plastic by solving the elastic problem at each time step. In our methodology, two treatments of the molten core are considered: one as a liquid and the other as a rubbery state. Our results suggest that the rubbery state treatment provides higher accuracy in predicting the deformation results, as it maintains the displacement of the localized thermal shrinkage in its vicinity. The validity of our method is supported by empirical measurements on produced parts from the existing literature as well as on samples that we molded independently.

• Jezik: Angleški jezik
• Ključne besede: thermoelasticity, injection molding, plastic, deformations
• Vrsta gradiva: Članek v reviji
• Tipologija: 1.01 - Izvirni znanstveni članek
• Organizacija: FMF - Fakulteta za matematiko in fiziko
• Različica publikacije: Objavljena publikacija
• Datum objave: 27.06.2023
• Leto izida: 2023
• Št. strani: 22 str.
• Številčenje: Vol. 15, art. no. ǂ2841
• PID: 20.500.12556/RUL-155548
• UDK: 621.767
• ISSN pri članku: 2073-4360
• DOI: 10.3390/polym15132841
• COBISS.SI-ID: 157351939
• Datum objave v RUL: 05.04.2024

Gradivo je del revije

• Naslov: Polymers
• Skrajšan naslov: Polymers
• Založnik: Molecular Diversity Preservation International
• ISSN: 2073-4360
• COBISS.SI-ID: 517951257

Licence

• Licenca: CC BY 4.0, Creative Commons Priznanje avtorstva 4.0 Mednarodna
• Povezava: http://creativecommons.org/licenses/by/4.0/deed.sl
• Opis: To je standardna licenca Creative Commons, ki daje uporabnikom največ možnosti za nadaljnjo uporabo dela, pri čemer morajo navesti avtorja.

Sekundarni jezik

• Jezik: Slovenski jezik
• Ključne besede: termoelastičnost, injekcijsko brizganje, plastika, deformacije