izpis_h1_title_alt

The dynamic behaviour of symmetrical laminated nano-composite containing equal numbers of glass and carbon fibre layers
ID Mohammed, Ava A. K. (Avtor), ID Hassan, Gailan Ismail (Avtor), ID Khdir, Younis Khalid (Avtor)

.pdfPDF - Predstavitvena datoteka, prenos (1,16 MB)
MD5: 7BC0776EFD577529EEC7CF8CB2F400A8
URLURL - Izvorni URL, za dostop obiščite https://www.sv-jme.eu/sl/article/dynamical-behavior-of-symmetrical-laminated-nano-composite-containing-equal-numbers-of-glass-and-carbon-fibers/ Povezava se odpre v novem oknu

Izvleček
Fibre-reinforced polymer composite has many uses in structural components that required high strength, stiffness, and damping capacity. Cross and quasi-laminated epoxy composites with and without nano Al2O3 were used in this investigation to determine flexural modulus, natural frequency, damping ratio, and mode shapes by using analytical, experimental, and numerical (ANSYS) methods. It was demonstrated that adding 2 % nano Al2O3 improved the flexural modulus and the damping ratio while decreased the natural frequency. Cross number 2 and quasi number 2 had the highest natural frequency for cross and quasi laminate groups which are equal to 23.5 Hz and 20.25 Hz experimentally, respectively. On the other hand, the higher damping ratio was achieved for cross number 1 with nano Al2O3 and quasi number 2 with nano Al2O3 for both cross and quasi laminates, which are equal to 0.707 % and 0.693 %, respectively. The flexural modulus and damping ratio are inversely related to each other. However, the novelty in this article is that by adding two glass plies at the outer surface of quasi group laminate the flexural modulus, natural frequency, and damping ratio are increased simultaneously, as in the configurations quasi number 2 and quasi number 2 with nano Al2O3 in comparison with quasi number 1 and quasi number 1 with nano Al2O3.

Jezik:Angleški jezik
Ključne besede:cross laminate, quasi laminate, natural frequency, damping ratio, nanoparts
Vrsta gradiva:Članek v reviji
Tipologija:1.01 - Izvirni znanstveni članek
Organizacija:FS - Fakulteta za strojništvo
Status publikacije:Objavljeno
Različica publikacije:Objavljena publikacija
Leto izida:2023
Št. strani:Str. 224-234
Številčenje:Vol. 69, no. 5/6
PID:20.500.12556/RUL-146675 Povezava se odpre v novem oknu
UDK:620.3:531.3
ISSN pri članku:0039-2480
DOI:10.5545/sv-jme.2022.403 Povezava se odpre v novem oknu
COBISS.SI-ID:154620163 Povezava se odpre v novem oknu
Datum objave v RUL:06.06.2023
Število ogledov:199
Število prenosov:21
Metapodatki:XML RDF-CHPDL DC-XML DC-RDF
:
Kopiraj citat
Objavi na:Bookmark and Share

Gradivo je del revije

Naslov:Strojniški vestnik
Skrajšan naslov:Stroj. vestn.
Založnik:Zveza strojnih inženirjev in tehnikov Slovenije [etc.], = Association of Mechanical Engineers and Technicians of Slovenia [etc.
ISSN:0039-2480
COBISS.SI-ID:762116 Povezava se odpre v novem oknu

Licence

Licenca:CC BY 4.0, Creative Commons Priznanje avtorstva 4.0 Mednarodna
Povezava:http://creativecommons.org/licenses/by/4.0/deed.sl
Opis:To je standardna licenca Creative Commons, ki daje uporabnikom največ možnosti za nadaljnjo uporabo dela, pri čemer morajo navesti avtorja.

Sekundarni jezik

Jezik:Slovenski jezik
Naslov:Dinamične lastnosti simetrično laminiranih nanokompozitov, ki vključujejo enako število steklenih in ogljikovih vlaken
Ključne besede:križni laminat, kvazi laminat, modul elastičnosti pri upogibu, lastna frekvenca, faktor dušenja, nanodelci

Podobna dela

Podobna dela v RUL:
Podobna dela v drugih slovenskih zbirkah:

Nazaj