Production of the design developed to assembly filter parts, optimization of welding and field test

Maden, Hakan (avtor), Cetinkaya, Kerim (avtor)

For the joining of non-removable plastic parts, methods such as friction welding, friction-stir welding, ultra-sonic welding, chemical joining, and hot-plate welding are used. Rotary friction welding is generally used for joining the filter parts of water treatment devices. After the rotating friction welding of the filter parts, semi-melted agglomerations are formed in the inner parts. To prevent semi-melted accumulation, a weld joint profile design was developed in the ABAQUS software in a previous study. In this study, injection moulds had been produced according to weld joint profile design. The taken plastic presses were welded with the friction welding machine and the joint was controlled and compared. It is seen that the semi-melted agglomeration was successfully confined. By performing Taguchi experimental method and ANOVA analysis on friction welding machine parameters, the optimum pressure conditions were determined in order to carry out static and dynamic tests according to NSF standards and field tests by producing 1500 pilot products, and it has been put into use. The lifetime of the developed filter depends on the material which was used in the manufacture. The next study is aimed to improve the lifetime of the developed filters.

• Jezik: Angleški jezik
• Ključne besede: rotary friction welding, taguchi experimental method, ANOVA analysis, semi-melt agglomerations, NSF water purification, field test, static testing, dynamic testing
• Vrsta gradiva: Članek v reviji
• Tipologija: 1.01 - Izvirni znanstveni članek
• Organizacija: FS - Fakulteta za strojništvo
• Status publikacije: Objavljeno
• Različica publikacije: Objavljena publikacija
• Datum objave: 01.11.2022
• Leto izida: 2022
• Št. strani: Str. 657-668
• Številčenje: Vol. 68, no. 11
• PID: 20.500.12556/RUL-143250
• UDK: 621.791
• ISSN pri članku: 0039-2480
• DOI: 10.5545/sv-jme.2022.255
• COBISS.SI-ID: 133048835
• Datum objave v RUL: 09.12.2022

Gradivo je del revije

• Naslov: Strojniški vestnik
• Skrajšan naslov: Stroj. vestn.
• Založnik: Zveza strojnih inženirjev in tehnikov Slovenije [etc.], = Association of Mechanical Engineers and Technicians of Slovenia [etc.
• ISSN: 0039-2480
• COBISS.SI-ID: 762116

Licence

• Licenca: CC BY 4.0, Creative Commons Priznanje avtorstva 4.0 Mednarodna
• Povezava: http://creativecommons.org/licenses/by/4.0/deed.sl
• Opis: To je standardna licenca Creative Commons, ki daje uporabnikom največ možnosti za nadaljnjo uporabo dela, pri čemer morajo navesti avtorja.

Sekundarni jezik

• Jezik: Slovenski jezik
• Naslov: Konstruiranje filtrov za montažo, optimizacija varjenja in terenski preizkusi
• Ključne besede: rotacijsko varjenje z gnetenjem, eksperimentalna metoda po Taguchiju, analiza ANOVA, kopičenje delno raztaljenih delcev, čiščenje vode NSF, analiza po metodi končnih elementov, terenski preizkus, statično preizkušanje, dinamično preizkušanje