izpis_h1_title_alt

Using sound in the very near field of vibrating plates for determination of their mechanical properties
ID Prezelj, Jurij (Avtor), ID Nikonov, Anatolij (Avtor), ID Emri, Igor (Avtor)

.pdfPDF - Predstavitvena datoteka, prenos (3,51 MB)
MD5: F8E483A6753053E67F5707670F64CC2B
URLURL - Izvorni URL, za dostop obiščite https://www.sciencedirect.com/science/article/pii/S0003682X21005806 Povezava se odpre v novem oknu

Izvleček
During the evaluation of Young’s modulus by vibroacoustic methods, it is usually assumed that the Poisson’s ratio is known. This assumption is based on a reasonable tolerance of the vibroacoustic methods to an inadequate estimate of Poisson’s ratio. However, most studies do not consider the influence of the Poisson’s ratio error in the estimation of the Young’s modulus error. Moreover, the evaluation of the total error typically does not include any parametric analysis at all. Therefore, a new vibroacoustic method is proposed that provides a simple and reciprocal determination of the Young’s modulus and Poisson’s ratio. The method is based on measurements of the natural vibration modes of elongated plates using a scanning microphone in the very near field. The results of the sound pressure scanning are interpolated with a quadratic harmonic function to improve the spatial resolution in locating the vibration nodes. The advantage of this method is that the Poisson’s ratio can be calculated directly by measuring the wavelength of the bending wave. Poisson’s ratio is otherwise much more difficult to measure than Young’s modulus. Therefore, this method can be used to determine the Poisson’s ratio of various polymers, wood, and composites. The parametric analysis of the proposed method is compared with the parametric analysis of the standardised ASTM 1875 method ‘‘Standard Test Method for Dynamic Young’s Modulus, Shear Modulus, and Poisson’s Ratio by Sonic Resonance”. The results show that the accuracy of the Poisson’s ratio determination is mainly influenced by the accuracy of the material density and the accuracy of the measured sample thickness. The accuracy of these two parameters also has a dominant influence on the accuracy of the determination of the Young’s modulus. The proposed method and its accuracy are demonstrated on three different plates: aluminium, steel and soft plexiglass. The results of the proposed method for aluminium were compared with those obtained by the standardised ASTM method. The proposed method provides smaller error for given experimental conditions.

Jezik:Angleški jezik
Ključne besede:acoustic very near field, sonic resonance, Poissonʼs ratio, Youngʹs modulus, plates, parametric analysis, microphone, vibrations
Vrsta gradiva:Članek v reviji
Tipologija:1.01 - Izvirni znanstveni članek
Organizacija:FS - Fakulteta za strojništvo
Status publikacije:Objavljeno
Različica publikacije:Objavljena publikacija
Leto izida:2021
Št. strani:13 str.
Številčenje:Vol. 186, art. 108486
PID:20.500.12556/RUL-138875 Povezava se odpre v novem oknu
UDK:534.8(045)
ISSN pri članku:1872-910X
DOI:10.1016/j.apacoust.2021.108486 Povezava se odpre v novem oknu
COBISS.SI-ID:84357123 Povezava se odpre v novem oknu
Datum objave v RUL:24.08.2022
Število ogledov:548
Število prenosov:249
Metapodatki:XML RDF-CHPDL DC-XML DC-RDF
:
Kopiraj citat
Objavi na:Bookmark and Share

Gradivo je del revije

Naslov:Applied Acoustics
Založnik:Elsevier
ISSN:1872-910X
COBISS.SI-ID:23258629 Povezava se odpre v novem oknu

Licence

Licenca:CC BY 4.0, Creative Commons Priznanje avtorstva 4.0 Mednarodna
Povezava:http://creativecommons.org/licenses/by/4.0/deed.sl
Opis:To je standardna licenca Creative Commons, ki daje uporabnikom največ možnosti za nadaljnjo uporabo dela, pri čemer morajo navesti avtorja.

Sekundarni jezik

Jezik:Slovenski jezik
Ključne besede:akustično bližnje polje, zvočna resonanca, Poissonovo število, Youngov modul, plošče, parametrična analiza, mikrofoni, nihanja

Projekti

Financer:ARRS - Agencija za raziskovalno dejavnost Republike Slovenije
Številka projekta:J2-9224
Naslov:Večparametrično dinamično modeliranje plastovitih močno nehomogenih elastičnih struktur

Financer:ARRS - Agencija za raziskovalno dejavnost Republike Slovenije
Številka projekta:P2-0401
Naslov:Energetsko strojništvo

Podobna dela

Podobna dela v RUL:
Podobna dela v drugih slovenskih zbirkah:

Nazaj