izpis_h1_title_alt

EL and LBIC characterization of cut edge recombination in IBC solar cells
ID Bokalič, Matevž (Avtor), ID Kikelj, Miha (Avtor), ID Brecl, Kristijan (Avtor), ID Jankovec, Marko (Avtor), ID Buchholz, Florian (Avtor), ID Mihailetchi, Valentin (Avtor), ID Topič, Marko (Avtor)

.pdfPDF - Predstavitvena datoteka, prenos (661,13 KB)
MD5: D7C9F0C04F384B05EA1C95C7CBC3E01F

Izvleček
The interconnection of cut cells is a way to improve cell to module efficiency ratio. While this approach minimizes series resistance losses and improves module area utilization, it introduces recombination losses due to imperfect cuts. We propose two additional methods to characterize edge recombination based on multi-wavelength light beam induced current (LBIC) measurements and current-dependent spatially resolved electroluminescence (EL). We test the methods on interdigitated back contact silicon solar cells, which were cut in our laboratory using a not yet optimized procedure with laser ablation and mechanical cleaving. The proposed LBIC based measurement offers an easy interpretation as its result can be directly linked to the local external quantum efficiency, while the proposed EL method can be used as an alternative to the established PL methods without the need of a light source. The results show a clear distinction between cut and uncut edges, which was observed with both methods. The influence of edge recombination is still evident 2 mm away from the cell edge in the EL measurements, and 1 mm and 0.5 mm in the LBIC measurements at 1060 and 642 nm, respectively. For the uncut edge the influence is smaller. Based on the LBIC measurements, the EQE loss at the cut edge is estimated to be 9% for a 1 mm and 0.5 mm wide area along the edge for 1060 and 642 nm, respectively. We also observed a non-intuitive EL behaviour, since the EL signal obtained with high current bias decreases faster towards the edge than the EL signal obtained with low bias current. Similarly, a difference between normalized LBIC profiles is observed at different wavelengths. For the uncut edge, the LBIC signal has a slightly steeper response at 1060 nm than at 642 nm.

Jezik:Angleški jezik
Ključne besede:electroluminescence, LBIC, edge recombination, IBC, silicon solar cells
Tipologija:1.08 - Objavljeni znanstveni prispevek na konferenci
Organizacija:FE - Fakulteta za elektrotehniko
Status publikacije:Objavljeno
Različica publikacije:Recenzirani rokopis
Leto izida:2020
Št. strani:Str. 308-311
PID:20.500.12556/RUL-134032 Povezava se odpre v novem oknu
UDK:621.383.51
ISSN pri članku:2196-100X
DOI:10.4229/EUPVSEC20202020-2CV.1.9 Povezava se odpre v novem oknu
COBISS.SI-ID:58036483 Povezava se odpre v novem oknu
Datum objave v RUL:22.12.2021
Število ogledov:916
Število prenosov:44
Metapodatki:XML RDF-CHPDL DC-XML DC-RDF
:
Kopiraj citat
Objavi na:Bookmark and Share

Gradivo je del zbornika

Naslov:37th European Photovoltaic Solar Energy Conference and Exhibition
COBISS.SI-ID:36337923 Povezava se odpre v novem oknu

Gradivo je del revije

Naslov:Proceedings
Založnik:WIP, Wirtschaft und Infrastruktur GmbH & Co Planungs KG
ISSN:2196-100X
COBISS.SI-ID:10276692 Povezava se odpre v novem oknu

Sekundarni jezik

Jezik:Slovenski jezik
Ključne besede:elektroluminiscenca, LBIC, rekombinacija na robu, IBC, prepleteni zadnji kontakti, multikristalni silicij, sončne celice

Projekti

Financer:EC - European Commission
Program financ.:H2020
Številka projekta:857793
Naslov:High-performance low-cost modules with excellent environmental profiles for a competitive EU PV manufacturing industry
Akronim:HighLite

Financer:ARRS - Agencija za raziskovalno dejavnost Republike Slovenije
Številka projekta:P2-0197
Naslov:Fotovoltaika in elektronika

Podobna dela

Podobna dela v RUL:
Podobna dela v drugih slovenskih zbirkah:

Nazaj