izpis_h1_title_alt

Dynamic modelling, experimental identification and computer simulations of non-stationary vibration in high-speed elevators
ID Đokić, Radomir (Avtor), ID Vladić, Jovan (Avtor), ID Kljajin, Milan (Avtor), ID Jovanović, Vesna (Avtor), ID Marković, Goran (Avtor), ID Karakašić, Mirko (Avtor)

URLURL - Izvorni URL, za dostop obiščite https://www.sv-jme.eu/sl/article/dynamic-modeling-experimental-identification-and-computer-simulations-of-non-stationary-vibration-in-high-speed-elevators/ Povezava se odpre v novem oknu
.pdfPDF - Predstavitvena datoteka, prenos (2,14 MB)
MD5: 014D0DBF62D1D1857A7F44EF06D7C934

Izvleček
Modelling the dynamic behaviour of elevators with high lifting velocities (contemporary elevators in building construction and mine elevators) is a complex task and an important step in the design process and creating conditions for safe and reliable exploitation of these machines. Due to high heights and lifting velocities, the standard procedures for dynamic exploitation are not adequate. The study presents the method of forming a dynamic model to analyse nonstationary vibrations of a rope with time-varying length with nonholonomic boundary conditions in the position where the rope is connected with the cabin (cage) and in the upcoming point of its winding onto the pulley (drum). A unique method was applied to identify the basic parameters of the dynamic model (stiffness and damping) based on experimental measures for a concrete elevator. Due to the verification of this procedure, the experiment was conducted on a mine elevator in RTB Bor, Serbia. Using the obtained computer-experimental results, the simulations of the dynamic behaviour of an empty and loaded cage were shown. In addition, the study shows the specific method as the basis for forming a control program that would enable the decrease in vertical vibrations during an elevator starting and braking mode.

Jezik:Angleški jezik
Ključne besede:high-speed elevators, dynamic analysis, steel ropes, longitudinal oscillations, control programs
Vrsta gradiva:Članek v reviji
Tipologija:1.01 - Izvirni znanstveni članek
Organizacija:FS - Fakulteta za strojništvo
Status publikacije:Objavljeno
Različica publikacije:Objavljena publikacija
Leto izida:2021
Št. strani:Str. 287-301
Številčenje:Vol. 67, no. 6
PID:20.500.12556/RUL-128360 Povezava se odpre v novem oknu
UDK:621.87
ISSN pri članku:0039-2480
DOI:10.5545/sv-jme.2020.7179 Povezava se odpre v novem oknu
COBISS.SI-ID:69784579 Povezava se odpre v novem oknu
Datum objave v RUL:09.07.2021
Število ogledov:723
Število prenosov:136
Metapodatki:XML RDF-CHPDL DC-XML DC-RDF
:
Kopiraj citat
Objavi na:Bookmark and Share

Gradivo je del revije

Naslov:Strojniški vestnik
Skrajšan naslov:Stroj. vestn.
Založnik:Zveza strojnih inženirjev in tehnikov Slovenije [etc.], = Association of Mechanical Engineers and Technicians of Slovenia [etc.
ISSN:0039-2480
COBISS.SI-ID:762116 Povezava se odpre v novem oknu

Sekundarni jezik

Jezik:Slovenski jezik
Naslov:Analiza dinamike linijske zobniške dvojice po numerični mnogoterostni metodi
Ključne besede:hitra dvigala, dinamična analiza, jeklene vrvi, vzdolžna nihanja, krmilni programi

Podobna dela

Podobna dela v RUL:
Podobna dela v drugih slovenskih zbirkah:

Nazaj