Analysis of additional load and fatigue life of preloaded bolts in a flange joint considering a bolt bending load

Okorn, Ivan (avtor), Nagode, Marko (avtor), Klemenc, Jernej (avtor), Oman, Simon (avtor)

The influence of the working load on the dynamic loading of the bolt was investigated in our study for two cases of flange joints. The analytical calculation according to the Verein Deutscher Ingenieure (VDI) 2230 recommendation and the numerical analysis using the finite element method (FEM) were performed for a model of a four-bolt joint. To verify the FEM analysis, the forces in the bolts were measured during preloading and during the application of the working load on the test rig. Based on the analytical and numerical results, the influence of the working load application point on the bolt load and its fatigue life was analysed for different cases. Comparison of the results shows that the analytical method overestimates the additional bolt stresses at low working load, mainly due to the extremely large fraction of bending stress. As the working load increases, the differences between the two methods decrease, but only for the reason that the analytical method can only linearly scale the overestimated results at lower working load, and FEM analysis, on the other hand, shows a progressive increase of the additional stress in the bolt at higher working loads due to the spreading of the flange. It is also shown that a high washer significantly increases the fatigue life of the bolt for two reasons: (i) a high washer reduces the additional stress in the bolt, and (ii) the high washer shifts the critical fatigue point from the thread area to the transition of the bolt shank to the head.

• Jezik: Angleški jezik
• Ključne besede: bolted joint, flange joint, preload, resilience, working load, load introduction factor, alternating stress range, fatigue life
• Vrsta gradiva: Članek v reviji
• Tipologija: 1.01 - Izvirni znanstveni članek
• Organizacija: FS - Fakulteta za strojništvo
• Status publikacije: Objavljeno
• Različica publikacije: Objavljena publikacija
• Leto izida: 2021
• Št. strani: 20 str.
• Številčenje: Vol. 11, iss. 3, art. 449
• PID: 20.500.12556/RUL-126175
• UDK: 620.178.3:519.61(045)
• ISSN pri članku: 2075-4701
• DOI: 10.3390/met11030449
• COBISS.SI-ID: 59147523
• Datum objave v RUL: 13.04.2021

Gradivo je del revije

• Naslov: Metals
• Skrajšan naslov: Metals
• Založnik: MDPI AG
• ISSN: 2075-4701
• COBISS.SI-ID: 15976214

Licence

• Licenca: CC BY 4.0, Creative Commons Priznanje avtorstva 4.0 Mednarodna
• Povezava: http://creativecommons.org/licenses/by/4.0/deed.sl
• Opis: To je standardna licenca Creative Commons, ki daje uporabnikom največ možnosti za nadaljnjo uporabo dela, pri čemer morajo navesti avtorja.
• Začetek licenciranja: 09.03.2021

Sekundarni jezik

• Jezik: Slovenski jezik
• Ključne besede: vijačna zveza, prirobnična zveza, prednapetje, togost vijačne zveze, delovna obremenitev, faktor prijemališča sile, amplituda napetosti, doba trajanja

Projekti

• Financer: ARRS - Agencija za raziskovalno dejavnost Republike Slovenije
• Številka projekta: P2-0182
• Naslov: Razvojna vrednotenja