Podrobno

Genome-wide in silico screening of genetic variability of microRNA genes in seven plant species
ID Zorc, Minja (Avtor), ID Kunej, Tanja (Avtor), ID Fekonja, Simon (Avtor)

URLURL - Predstavitvena datoteka, za dostop obiščite http://www.pomics.com/kunej_8_6_2015_544_548.pdf Povezava se odpre v novem oknu

Jezik:Angleški jezik
Ključne besede:rastline, genetika, mikroRNK, genetska variabilnost
Vrsta gradiva:Delo ni kategorizirano
Tipologija:1.01 - Izvirni znanstveni članek
Organizacija:BF - Biotehniška fakulteta
Leto izida:2015
Št. strani:Str. 544-548
Številčenje:Vol. 8, no. 6
PID:20.500.12556/RUL-82546 Povezava se odpre v novem oknu
UDK:575
ISSN pri članku:1836-3644
COBISS.SI-ID:3663752 Povezava se odpre v novem oknu
Datum objave v RUL:25.05.2016
Število ogledov:2002
Število prenosov:279
Metapodatki:XML DC-XML DC-RDF
:
ZORC, Minja, KUNEJ, Tanja in FEKONJA, Simon, 2015, Genome-wide in silico screening of genetic variability of microRNA genes in seven plant species. Plant omics [na spletu]. 2015. Vol. 8, no. 6, p. 544–548. [Dostopano 27 marec 2025]. Pridobljeno s: http://www.pomics.com/kunej_8_6_2015_544_548.pdf
Kopiraj citat
Objavi na:Bookmark and Share

Gradivo je del revije

Naslov:Plant omics
Založnik:Southern Cross Journals
ISSN:1836-3644
COBISS.SI-ID:524705561 Povezava se odpre v novem oknu

Podobna dela

Podobna dela v RUL:
  1. Karakterizacija zlitine AlSi7Mg0,3
  2. effect of heat treatment on the microstructure and mechanical properties of the SLM products from maraging steel
  3. effect of heat treatments on microstructure and mechanical properties of SLM Ti6Al4V alloy
  4. lithium addition to aluminium cast alloys
  5. detection of microstructural changes during heat treatment of 3D-printed aluminium alloys AlSi10Mg measurement of electrical resistivity
Podobna dela v drugih slovenskih zbirkah:
  1. The influence of manufacturing parameters on properties of Ti-6Al-4V products fabricated by selective laser melting, and their surface coating with bioactive polymer
  2. Comparative study of the microstructure and properties of cast-fabricated and 3D-printed laser-sintered Co–Cr alloys for removable partial denture frameworks
  3. Influence of the working technology on the development of alloys H13-w(Cu) 87.5 %
  4. Influence of selective laser melting parameters on mechanical properties of products
  5. Determination of process parameters for selective laser melting technology

Nazaj