Podrobno

Genetic variability of microRNA regulome in human
ID Kunej, Tanja (Avtor), ID Dovč, Peter (Avtor), ID Obšteter, Jana (Avtor)

URLURL - Predstavitvena datoteka, za dostop obiščite http://onlinelibrary.wiley.com/doi/10.1002/mgg3.110/abstract;jsessionid=25974E784F8C4521B49532A4841ECD72.f01t01 Povezava se odpre v novem oknu

Jezik:Angleški jezik
Ključne besede:molekularna genetika, mikro RNK, genetska variabilnost
Vrsta gradiva:Delo ni kategorizirano
Tipologija:1.01 - Izvirni znanstveni članek
Organizacija:BF - Biotehniška fakulteta
Leto izida:2015
Št. strani:Str. 30-39
Številčenje:Vol. 3, no. 1
PID:20.500.12556/RUL-82529 Povezava se odpre v novem oknu
UDK:575
ISSN pri članku:2324-9269
DOI:10.1002/mgg3.110 Povezava se odpre v novem oknu
COBISS.SI-ID:3426440 Povezava se odpre v novem oknu
Datum objave v RUL:25.05.2016
Število ogledov:2246
Število prenosov:286
Metapodatki:XML DC-XML DC-RDF
:
KUNEJ, Tanja, DOVČ, Peter in OBŠTETER, Jana, 2015, Genetic variability of microRNA regulome in human. Molecular genetics & genomic medicine [na spletu]. 2015. Vol. 3, no. 1, p. 30–39. [Dostopano 27 marec 2025]. DOI 10.1002/mgg3.110. Pridobljeno s: http://onlinelibrary.wiley.com/doi/10.1002/mgg3.110/abstract;jsessionid=25974E784F8C4521B49532A4841ECD72.f01t01
Kopiraj citat
Objavi na:Bookmark and Share

Gradivo je del revije

Naslov:Molecular genetics & genomic medicine
Skrajšan naslov:Mol. genet. genomic med.
Založnik:John Wiley & Sons
ISSN:2324-9269
COBISS.SI-ID:3426184 Povezava se odpre v novem oknu

Podobna dela

Podobna dela v RUL:
  1. Karakterizacija zlitine AlSi7Mg0,3
  2. effect of heat treatment on the microstructure and mechanical properties of the SLM products from maraging steel
  3. effect of heat treatments on microstructure and mechanical properties of SLM Ti6Al4V alloy
  4. lithium addition to aluminium cast alloys
  5. detection of microstructural changes during heat treatment of 3D-printed aluminium alloys AlSi10Mg measurement of electrical resistivity
Podobna dela v drugih slovenskih zbirkah:
  1. The influence of manufacturing parameters on properties of Ti-6Al-4V products fabricated by selective laser melting, and their surface coating with bioactive polymer
  2. Comparative study of the microstructure and properties of cast-fabricated and 3D-printed laser-sintered Co–Cr alloys for removable partial denture frameworks
  3. Influence of the working technology on the development of alloys H13-w(Cu) 87.5 %
  4. Influence of selective laser melting parameters on mechanical properties of products
  5. Determination of process parameters for selective laser melting technology

Nazaj