In the master's thesis, we did the feasibilty study for postional and geometric quality homogenization of cadastral index map in the area of the Cadastral Community 392 Krčevina pri Ptuju, which consists three parts. First we have prepared the input data and eliminated the topological mistakes (errors) in the enitre Cadastral Community. The software Systra was used for enitre procedure of homogenization of cadastral index map, seperately for each part of Cadastral Community and in two different ways. With adding the conditions of relative geometry to the model of adjustment, we wanted to improve the cadastral index map on the areas with lower density of quality points. We analyzed the results of homogenization in the software SysGeoPro. We fixed the topological errors and other distortions in the area of consideration. When we get the results, we made a comparative analysis of both ways of homogenization that we made and also studied the efect on result on postional homogenization of cadastral index map with addding the conditions of relative geometry. We found out that the quality of the cadastral index map is dependent on the original cadastral data and methods of maintenance of the grafical (cadastral) index map. We realized that we can improve the quality of cadastral index map with the process of homogenization. To increase the reliability of these, we must increase the number of observation that we made.