In dimensional measurements on a coordinate measuring machine, even minimal changes in the measurement strategy can have a significant impact on the measurement result. In the thesis, we examined the influence of the probe tilt on the measured value. We performed measurements in which we touched the surface of the calibration sphere at the same points with different measuring probe tilts. In addition, we measured the influences of the probe size, the traversing speed, and the displacement to the extreme position. All measured influences were compared in magnitude both with the prescribed maximum permissible error and among themselves. In general, it can be concluded that the influence of the probe angle is very large, but does not exceed the maximum permissible measuring error that is defined in the specifications of the measuring device.
|
