In the deep drawing process, the wall of the product becomes thinner. Since this is influenced
by several factors, at the beginning of the thesis we investigated sheet metal forming and
deep drawing. Deep drawing is the foundation of this thesis, so we have described the
process and parameters in detail. Based on this, we determined three main parameters with
which we conducted the experiment. The Taguchi method was used to design the
experiments. The experiment was carried out on a hydraulic press. To measure the thickness
of the wall, we first investigated the ways and methods of measurement. Based on this, we
chose the method with which we measured the minimum thickness of the wall of the pot. At
the end of the thesis, we analyzed the results, calculated the measurement uncertainty and
using the program obtained an equation representing the influence of the initial parameters.
With the program, we found that the selected parameters have a significant impact on the
wall thickness of the product.
|
