Open Science Slovenia
New in RUL
A method for enhanced polymer spur gear inspection based on 3D optical metrology
PDF - Presentation file,
URL - Source URL, Visit
Accurately manufactured gears require a reliable, holistic, and fast inspection method. Standardised geometrical parameters enable a consistent and regulated inspection of gears; however, current inspection methods include only a limited set of measurements for gears at specific locations. Therefore, a method to obtain holistic three-dimensional (3D) measurements with an optical inspection was thoroughly investigated. The measurement data were acquired via 3D optical scanning. The data were then processed and evaluated using the developed software. This was first tested on a simulated scan of an ideal shape with different mesh resolutions and subsequently on a simulated scan with synthetic deviations. The method was finally validated by measuring the gears using a coordinate-measuring machine; the results obtained were compared with those obtained using the developed optical method. A good agreement between the methods was observed. The optical method offers a more holistic measurement approach with many important advantages being identified compared with the tactile method.
1.01 - Original Scientific Article
FS - Faculty of Mechanical Engineering
Number of pages:
ISSN on article:
Voting is allowed only to
Cite this work
Record is a part of a journal
Institute of Measurement and Control
Document is financed by a project
ARRS - Agencija za raziskovalno dejavnost Republike Slovenije (ARRS)
Drugi - Drug financer ali več financerjev
European Regional Development Fund
Similar works from RUL:
Similar works from other Slovenian collections:
You have to
to leave a comment.
0 - 0 / 0
There are no comments!