Naprava za testiranje pnevmatskih manipulatorjev

MASIČ, TINE (author), Murovec, Boštjan (mentor)

V diplomskem delu sta predstavljena razvoj in izdelava naprave za testiranje pnevmatskih manipulatorjev. Izdelek je namenjen podjetju Hidria, d.o.o., Kompetenčni center v Kopru, ki se ukvarja z industrijsko avtomatizacijo. Zamisel je nastala iz potrebe v proizvodnji, kjer sestavljajo proizvodne linije. Le-te najprej načrtujejo projektanti. Izdelajo se tako konstrukcijski načrti, električne vezalne sheme, da lahko končni produkt nato delavci sestavijo. Pri tem se srečujejo z najrazličnejšimi problemi ter neskladji, zato je ključna faza testiranja. Vsak sestavljen sklop pnevmatskih aktuatorjev, ki so sestavni deli linije, je potrebno natančno kalibrirati. Za tovrstno testiranje sklopa delavci niso imeli nobene naprave, ki bi jim delo poenostavila, zato se je tudi porodila ideja za diplomsko nalogo. Dosedanje testiranje je potekalo tako, da so delavci vsak pnevmatski cilinder povezali na pnevmatski blok, kjer so jih posamezno ročno prožili. Tak način testiranja je zamuden in ne omogoča vseh funkcionalnosti, ki jih ponuja izdelana naprava. Želja delavcev je bila, da bi se pnevmatski aktuatorji prožili po vpisani sekvenci. V ta namen smo si zamislili vmesnik med delavcem in strojem, ki od delavca ne zahteva programskega znanja. Diplomska naloga sloni na Siemensovih programirljivih logičnih krmilnikih (PLK) ter programiranju le-teh.

• Language: Slovenian
• Keywords: Pnevmatski aktuatorji, industrijska avtomatizacija, avtomatizacija testiranja
• Work type: Bachelor thesis/paper
• Organization: FE - Faculty of Electrical Engineering
• Year: 2020
• PID: 20.500.12556/RUL-116574
• Publication date in RUL: 28.05.2020

MASIČ, TINE, 2020, Naprava za testiranje pnevmatskih manipulatorjev [online]. Bachelor’s thesis. [Accessed 8 July 2025]. Retrieved from: https://repozitorij.uni-lj.si/IzpisGradiva.php?lang=eng&id=116574

Secondary language

• Language: English
• Title: Device for testing pneumatic manipulators

Abstract

The thesis presents development and construction of a device for testing pneumatic manipulators. The product is intended for Hidria, d.o.o., Kompetenčni center in Koper, which deals with industrial automation. The idea came from the needs in production where automated production lines are assembled. These are first planned by the designers. Construction plans and electrical wiring diagrams are made so that the finished product can be then assembled by workers. In that phase they face many problems and discrepancies, which is why the testing phase is crucial. Each assembled set of pneumatic actuators that are part of the line must be carefully calibrated. For this type of testing, the workers did not have any devices to simplify their work, thus the idea for the thesis was born. So far the testing has been carried out by workers linking each pneumatic cylinder to a pneumatic block where they were individually actuated. This type of testing is time-consuming and does not allow all the functionality offered by a manufactured device. It was the desire of the workers that the pneumatic actuators would be actuated by the entered sequence. To this end, we envisioned an interface between the worker and the machine, which does not require the programmer's programming knowledge. The thesis is based on Siemens Programmable Logic Controllers (PLCs) and their programming.

• Keywords: Pneumatic actuators, industrial automation, testing automation