Advanced

 
  Search
    Simple search


Results

4 results
1 - 4 / 4
First pagePrevious page1Next pageLast page
1. Simulations of the shrinkage porosity of Al-Si-Cu automotive components
Lejla Lavtar, Mitja Petrič, Jožef Medved, Boštjan Taljat, Primož Mrvar, 2012, professional article

Keywords: visokotlačno litje, aluminij-silicij-bakrova zlitina, krčilna poroznost, ProCast, high-pressure die casting, aluminium-silicon-copper alloy, shrinkage porosity, ProCast software
Full text (outside link)

2. Monitoring of injection moulding of thermoplastics
Vito Speranza, Umberto Vietri, Roberto Pantani, 2013, original scientific article

Keywords: injection moulding, quality control, shrinkage
Full text (outside link)

3. Reduction of the early autogenous shrinkage of high strength concrete
Drago Saje, 2015, original scientific article

Keywords: beton visoke trdnosti, avtogeno krčenje betona, lahek agregat, polipropilenska vlakna, concrete, high strength concrete, autogenous shrinkage of concrete, lightwieght aggregate, polypropylene fibres
Full text (outside link)

4. Injection molding simulation with solid semi-crystalline polymer mechanical behavior for ejection analysis
Nikolaj Mole, Kristjan Krebelj, Boris Štok, original scientific article

Keywords: injection molding, numerical simulation, residual stresses, shrinkage, ejection
Full text (file, 2,65 MB)
Search done in 0.02 sec.
Back to top