Advanced

 
  Search
    Simple search


Results

53 results
1 - 10 / 53
First pagePrevious page123456Next pageLast page
1. Numerical simulations in optimisation of product and forming process
Tomaž Pepelnjak, Gašper Gantar, Karl Kuzman, 2001, original scientific article

Keywords: concurrent engineering, numerical simulations, stamping process, blank optimisation
Full text (outside link)

2. Analysis and elimination of the stretcher strains on TH415 tinplate rings in the stamping process
Tomaž Pepelnjak, Branimir Barišić, 2007, original scientific article

Keywords: obdelave pločevine, štancanje, modeli končnih elementov, simuliranje, materiali, tanki obroči, geometrija orodij, optimiranje orodij, optimisation, stretcher strains, stamping, FEM simulation
Full text (outside link)

3. Predicting of the Lüder's bands in the processing of TH material in computer environment by means of stohastic modeling
Branimir Barišić, Tomaž Pepelnjak, Miljenko D. Math, 2008, original scientific article

Keywords: štancanje, plastične deformacije, stohastično modeliranje, geometrična stabilnost, procesni parametri, materialne lastnosti, stamping, plastic deformation, stohastic modeling, geometrical stability, process parameters, material properies
Full text (outside link)

4. Computer-assisted engineering determination of the formability limit for thin sheet metals by a modified Marciniak method
Tomaž Pepelnjak, Branimir Barišić, 2009, original scientific article

Keywords: krivulje mejnih deformacij, metoda Marciniak, preoblikovanje pločevine, končni elementi
Full text (outside link)

5. Analysis of deformation characteristics of magnesium AZ80 wrought alloy under hot conditions
Dominik Kobold, Tomaž Pepelnjak, Gašper Gantar, Karl Kuzman, 2010, original scientific article

Keywords: magnesium forging, anisotropy, plastic deformation, flow curves
Full text (outside link)

6. Nova metoda za določevanje krivulje mejnih deformacij v digitalnem okolju
Aleš Petek, Tomaž Pepelnjak, Karl Kuzman, 2005, review article

Full text (outside link)

7. Numerične analize preoblikovanja cevi z visokim notranjim tlakom
Tomaž Pepelnjak, 2004, short scientific article

Full text (outside link)

8. Analize kakovosti pridrževanja pločevine pri globokem vleku
Tomaž Pepelnjak, Zlatko Kampuš, 2001, short scientific article

Full text (outside link)

9. The impact of strain rate on sheet metal formability at room temperature
Tomaž Pepelnjak, Sanja Smoljanić, 2013, original scientific article

Keywords: sheet metal forming, deep drawing, strain rate, room temperature forming
Full text (outside link)

10. Characterisation of polyamide (PA)12 nanocomposites with montmorillonite (MMT) filler clay used for the incremental forming of sheets
Andrej Borić, Alena Kalendová, Michal Urbanek, Tomaž Pepelnjak, 2019, original scientific article

Keywords: polymers, nanocomposites, polyamide PA12, clays, Cloisite 93A, morphology, mechanical properties
Full text (file, 4,01 MB)
Search done in 0.16 sec.
Back to top