Krmiljenje prototipne naprave za nanašanje spajke na tuljavnike, njihovo kontroliranje in pakiranje

DUJC, PRIMOŽ (avtor), Rozman, Robert (mentor)

V diplomskem delu smo izdelali programsko opremo za krmiljenje prototipne naprave, ki skrbi za avtomatiziran nanos spajke na prosta konca žičk tuljavnikov, kontrolo upornosti tuljavnikov, pakiranje dobrih tuljavnikov na paleto in slabih v predal slabih tuljavnikov. Delovno mesto je sedaj prijaznejše, varnejše in bolj zdravo do operaterja naprave ter proizvodni proces učinkovitejši. Nanos spajke na prosta konca žičk tuljavnika je sedaj bolj natančen in nadzorovan. Pri samodejnem merjenju upornosti so odstranjeni vplivi operaterja meritve se sedaj izvajajo pod bolj konstantnimi pogoji. Krmilni del prototipne naprave temelji na programirljivem logičnem krmilniku Omron CP1L in barvnem zaslonu občutljivem na dotik Omron NQ5. Za razvoj programske opreme krmilnika smo uporabili Omronovo programsko orodje CX-Programmer, za razvoj grafičnega uporabniškega vmesnika na zaslonu pa Omronovo programsko orodje NQ-Designer.

• Jezik: Slovenski jezik
• Ključne besede: Tuljavnik, PLC, krmilnik, CX-Programmer, NQ-Designer
• Vrsta gradiva: Diplomsko delo/naloga
• Organizacija: FRI - Fakulteta za računalništvo in informatiko
• Leto izida: 2014
• PID: 20.500.12556/RUL-29442
• Datum objave v RUL: 09.09.2014

Sekundarni jezik

• Jezik: Angleški jezik
• Naslov: A control software of the prototype device for automated application of solder on coils, their verification and packaging

Izvleček

In the thesis we have developed control software for the prototype device that performs automated application of solder on the free ends of the coil wires, verification of coil resistance and packaging of the good coils on the palette and bad ones in the drawer for bad coils. The workplace is now friendlier, safer and healthier to the operator and more efficient in the production process. An application of the solder to the free ends of the coil wires is now far more accurate and supervised. The influence of the human operator has been eliminated with automatic measurement of resistance; now they are performed under more constant conditions. The control part of the prototype device is based on programmable logic controller Omron CP1L and on a color touchscreen Omron NQ5. The Omron software tool CX-Programmer was used for the development of the software for the logic controller. For the development of the graphical user interface for touchscreen Omron software tool NQ-Designer was used.

• Ključne besede: Coil, PLC, controller, CX-Programmer, NQ-Designer