Optimizacija izdelave poliuretanske pene z uporabo utekočinjenega lesa : diplomsko delo

Mihalić, Davor (avtor), Tišler, Vesna (mentor), Kunaver, Matjaž (komentor), Pohleven, Franc (recenzent)

Z uporabo utekočinjenega lesa smo optimizirali izdelavo poliuretanskih pen. Na osnovi že znanih postopkov smo utekočinili les in iz njega naredili linearni poliester. Zato smo uporabili žagovino topolovine, dietilenglikol in žveplovo(VI)kislino. Zaestrenje je potekalo z uporabo anhidrida ftalne in adipinske kisline. Izdelali smo devet različnih pen in ugotovili, da so bile gostote vseh pen približno enake, in da so vse pene zelo absorbirale vodo. Take pene so primerne za uporabo v cvetličarstvu.

• Jezik: Slovenski jezik
• Ključne besede: utekočinjanje lesa, topol, sinteza poliestra, poliuretanska pena
• Vrsta gradiva: Diplomsko delo
• Tipologija: 2.11 - Diplomsko delo
• Organizacija: BF - Biotehniška fakulteta
• Kraj izida: Ljubljana
• Založnik: [D. Mihalić]
• Leto izida: 2007
• Št. strani: VIII, 49 f.
• PID: 20.500.12556/RUL-256
• UDK: 678.664
• COBISS.SI-ID: 1601417
• Datum objave v RUL: 11.07.2014

Sekundarni jezik

• Jezik: Angleški jezik
• Naslov: Optimization of polyurethane foam production using liquefied wood : visokošolski strokovni študij

Izvleček

Using liquefied wood the production of polyurethane foam was optimised. Wood was liquefied on the basis of already known methods, then linear polyester was produced, and later used to make polyurethane foams. To produce liquefied wood poplar sawdust, dietilenglycol and sulphur(VI)acid were used. Anhydride of phtalic and adipic acid were used for etherification. Nine different foams were produced. It was found out that the density of all the foams was similar, and that all the foams absorbed water very well. The foams are suitable for use in florist shops.

• Ključne besede: liquefied wood, poplar, polyester synthesis, polyurethane foams