Nanoporous stainless steel materials for body implants—review of synthesizing procedures

Benčina, Metka (avtor), Junkar, Ita (avtor), Vesel, Alenka (avtor), Mozetič, Miran (avtor), Iglič, Aleš (avtor)

Despite the inadequate biocompatibility, medical-grade stainless steel materials have been used as body implants for decades. The desired biological response of surfaces to specific applications in the body is a highly challenging task, and usually not all the requirements of a biomaterial can be achieved. In recent years, nanostructured surfaces have shown intriguing results as cell selectivity can be achieved by specific surface nanofeatures. Nanoporous structures can be fabricated by anodic oxidation, which has been widely studied for titanium and its alloys, while no systematic studies are so far available for stainless steel (SS) materials. This paper reviews the current state of the art in the anodisation of SS; correlations between the parameters of anodic oxidation and the surface morphology are drawn. The results reported by various authors are scattered because of a variety of experimental configurations. A linear correlation between the pores’ diameter anodisation voltage was deduced, while no correlation with other processing parameters was found obvious. The analyses of available data indicated a lack of systematic experiments, which are recommended to understand the kinetics of pore formation and develop techniques for optimal biocompatibility of stainless steel.

• Jezik: Angleški jezik
• Ključne besede: stainless steel, anodisation, nanoporous morphology
• Vrsta gradiva: Članek v reviji
• Tipologija: 1.02 - Pregledni znanstveni članek
• Organizacija: FE - Fakulteta za elektrotehniko
• Status publikacije: Objavljeno
• Različica publikacije: Objavljena publikacija
• Leto izida: 2022
• Št. strani: 15 str.
• Številčenje: Vol. 12, iss. 17, art. 2924
• PID: 20.500.12556/RUL-155613
• UDK: 620.1/.2
• ISSN pri članku: 2079-4991
• DOI: 10.3390/nano12172924
• COBISS.SI-ID: 122161155
• Datum objave v RUL: 08.04.2024

Gradivo je del revije

• Naslov: Nanomaterials
• Skrajšan naslov: Nanomaterials
• Založnik: MDPI AG
• ISSN: 2079-4991
• COBISS.SI-ID: 523286297

Licence

• Licenca: CC BY 4.0, Creative Commons Priznanje avtorstva 4.0 Mednarodna
• Povezava: http://creativecommons.org/licenses/by/4.0/deed.sl
• Opis: To je standardna licenca Creative Commons, ki daje uporabnikom največ možnosti za nadaljnjo uporabo dela, pri čemer morajo navesti avtorja.

Projekti

• Financer: ARRS - Agencija za raziskovalno dejavnost Republike Slovenije
• Številka projekta: J3-3074
• Naslov: Inovativni postopki obdelave površin za napredne lastnosti medicinskega jekla

• Financer: ARRS - Agencija za raziskovalno dejavnost Republike Slovenije
• Številka projekta: P2-0082
• Naslov: Tankoplastne strukture in plazemsko inženirstvo površin