izpis_h1_title_alt

Influence of load mass, drum speed and load composition on evenness of drying in a heat pump tumble dryer
ID Gatarić, Pero (Avtor), ID Širok, Brane (Avtor), ID Hočevar, Marko (Avtor), ID Novak, Lovrenc (Avtor)

.pdfPDF - Predstavitvena datoteka, prenos (2,42 MB)
MD5: AB407558F694A1872D710DFF281026F2
URLURL - Izvorni URL, za dostop obiščite https://www.tandfonline.com/doi/full/10.1080/07373937.2021.1928688 Povezava se odpre v novem oknu

Izvleček
This work investigates the evenness of fabric drying in a household heat pump tumble dryer. The evenness of drying was defined as the standard deviation of the fraction of water, evaporated from each fabric item. Drying experiments were performed according to the IEC 61121 standard, which was also followed to determine quantities and types of cotton fabric items (towels, pillowcases and sheets) within each load. Regression analysis was performed to develop models for evenness of drying as a function of load mass and drum speed. Similarities between the tumble dryer energy efficiency parameters and the evenness of drying were analyzed. A high level of agreement was determined between responses of energy efficiency, drying time and evenness of drying to changes in drum speed. Effects of load mass were however more complex and were reflected in a non-linear response of evenness of drying to changes in load mass – the best evenness of drying could be obtained at 2 kg load, followed by 6 kg and 4 kg load. Load composition was determined as an important factor affecting the evenness of drying. At larger loads, a sheet or a pillowcase in average contributed more to the un-evenness of drying than a towel. The presence of sheets and probably the ratio of sheets to other item types in the load were determined as the most probable factors that negatively affected the evenness of drying.

Jezik:Angleški jezik
Ključne besede:heat pump tumble dryers, evenness of drying, regression analysis, energy efficiency
Vrsta gradiva:Članek v reviji
Tipologija:1.01 - Izvirni znanstveni članek
Organizacija:FS - Fakulteta za strojništvo
Status publikacije:Objavljeno
Različica publikacije:Objavljena publikacija
Leto izida:2022
Št. strani:Str. 2175–2187
Številčenje:Vol. 40, iss. 10
PID:20.500.12556/RUL-141026 Povezava se odpre v novem oknu
UDK:621.577:648.336
ISSN pri članku:0737-3937
DOI:10.1080/07373937.2021.1928688 Povezava se odpre v novem oknu
COBISS.SI-ID:65575939 Povezava se odpre v novem oknu
Datum objave v RUL:22.09.2022
Število ogledov:654
Število prenosov:121
Metapodatki:XML DC-XML DC-RDF
:
Kopiraj citat
Objavi na:Bookmark and Share

Gradivo je del revije

Naslov:Drying technology
Skrajšan naslov:Dry. technol.
Založnik:Taylor & Francis
ISSN:0737-3937
COBISS.SI-ID:5922823 Povezava se odpre v novem oknu

Licence

Licenca:CC BY-NC-ND 4.0, Creative Commons Priznanje avtorstva-Nekomercialno-Brez predelav 4.0 Mednarodna
Povezava:http://creativecommons.org/licenses/by-nc-nd/4.0/deed.sl
Opis:Najbolj omejujoča licenca Creative Commons. Uporabniki lahko prenesejo in delijo delo v nekomercialne namene in ga ne smejo uporabiti za nobene druge namene.

Sekundarni jezik

Jezik:Slovenski jezik
Ključne besede:sušilniki perila s toplotno črpalko, enakomernost sušenja, regresijska analiza, energijska učinkovitost

Projekti

Financer:ARRS - Agencija za raziskovalno dejavnost Republike Slovenije
Številka projekta:P2-0401
Naslov:Energetsko strojništvo

Financer:Drugi - Drug financer ali več financerjev
Program financ.:Republic of Slovenia, SPS
Številka projekta:OP20.00376
Akronim:IQDOM

Financer:EC - European Commission
Program financ.:European Regional Development Fund, SPS
Akronim:IQDOM

Podobna dela

Podobna dela v RUL:
Podobna dela v drugih slovenskih zbirkah:

Nazaj