Influence of simple and double-weave structures on the adhesive properties of 3D printed fabrics

Čuk, Marjeta (avtor), Bizjak, Matejka (avtor), Kočevar, Tanja Nuša (avtor)

The double-weave structure of a fabric allows for the use of different materials and weave structures for the upper and lower layer, which can be advantageous in the functionalization of 3D printed textiles. Therefore, the aim of this research was to investigate the influence of simple and double-weave structures on the adhesion of 3D printed fabrics. From this perspective, we investigated the influence of different twill derivates and weft densities on the adhesion force. We produced fabrics specifically for this study and printed them with a polylactic acid filament using Fused Deposition Modeling technology. The T-peel test was performed to measure the adhesion, and the results were statistically analyzed. A morphological study of the surfaces and cross-sections of the 3D printed fabrics helped us interpret the results. We found that adhesion was higher for double fabrics when printed with a smaller z-distance, where the molten polymer reached the lower layer of the fabric and adhered to it. The opposite was confirmed when printing with a larger z-distance, where adhesion was higher for simple fabrics. Both weave and density had a significant effect on adhesion in all cases. Surprisingly, different twill derivatives generally had a greater influence on adhesion than density.

• Jezik: Angleški jezik
• Ključne besede: 3D printing, adhesion, simple weave, double weave, morphology, z-distance
• Vrsta gradiva: Članek v reviji
• Tipologija: 1.01 - Izvirni znanstveni članek
• Organizacija: NTF - Naravoslovnotehniška fakulteta
• Status publikacije: Objavljeno
• Različica publikacije: Objavljena publikacija
• Leto izida: 2022
• Št. strani: 18 str.
• Številčenje: Vol. 14, iss. 4, art. 755
• PID: 20.500.12556/RUL-137293
• UDK: 677
• ISSN pri članku: 2073-4360
• DOI: 10.3390/polym14040755
• COBISS.SI-ID: 97600003
• Datum objave v RUL: 09.06.2022

Gradivo je del revije

• Naslov: Polymers
• Skrajšan naslov: Polymers
• Založnik: MDPI
• ISSN: 2073-4360
• COBISS.SI-ID: 517951257

Licence

• Licenca: CC BY 4.0, Creative Commons Priznanje avtorstva 4.0 Mednarodna
• Povezava: http://creativecommons.org/licenses/by/4.0/deed.sl
• Opis: To je standardna licenca Creative Commons, ki daje uporabnikom največ možnosti za nadaljnjo uporabo dela, pri čemer morajo navesti avtorja.
• Začetek licenciranja: 15.02.2022

Sekundarni jezik

• Jezik: Slovenski jezik
• Ključne besede: 3D tiskanje, tkanje

Projekti

• Financer: ARRS - Agencija za raziskovalno dejavnost Republike Slovenije
• Številka projekta: P2-0213
• Naslov: Tekstilije in ekologija