The use of fossil fuels as a primary energy source has had a strong impact on increased concentration levels of CO2 in the atmosphere in recent decades. However, global warming is increasingly becoming a major threat. One of the alternative sources of fossil fuels is hydrogen, which is used as a fuel in fuel cells. Here, energy is obtained by converting chemical energy into electricity. In a fuel cell, a reaction takes place between hydrogen and oxygen, which reacts to water. The main advantage of fuel cells is that they do not produce CO2. Their main disadvantage, however, is the price, which stems mainly from the price of the catalyst. Currently, platinum is used as a catalyst in fuel cells, which is very expensive as it is not abundant on Earth. As a result, a more cost-effective alternative to platinum, which will have comparable electrocatalytic properties to platinum, has been sought in recent years. Graphene and its modifications currently show good potential for platinum catalyst replacement, especially nitrogen-doped graphene (N-graphene).
As part of my research, we developed and set up a new N-graphene synthesis system where the synthesis takes place in just a few minutes. I synthesized the samples from four different initial precursors, namely, two different types of graphite (KS44 and KS6L) and two different types of multi-walled carbon nanotubes (C-grade and M-grade) were used. The samples were pre-oxidized by the improved Hummers method to graphene oxide and graphene oxide nanoribbons. The oxidized samples were then doped by pyrolysis in an NH3 atmosphere at temperatures 800°C, 1000°C and 1200°C. I compared these samples with undoped samples prepared by pyrolysis under a nitrogen atmosphere.
The new synthesis proved to be successful, with faster heating we obtained samples with a higher specific surface area and nitrogen content. All samples exhibited better electro-catalytic properties due to the new synthesis. I compared the electro-catalytic properties of the samples in acidic and alkaline media. All samples had better stability and activity for ORR in alkaline medium. Meanwhile, the samples had better selectivity for 4-electron pathway ORR in acidic medium. The sample with the best electrocatalytic properties was the doped sample synthesized from the M-grade type of multi-walled carbon nanotubes in both media.
|