Podrobno

A regenerative elastocaloric heat pump
ID Tušek, Jaka (Avtor), ID Engelbrecht, Kurt (Avtor), ID Eriksen, Dan (Avtor), ID DallʹOlio, Stefano (Avtor), ID Tušek, Janez (Avtor), ID Pryds, Nini (Avtor)

.pdfPDF - Predstavitvena datoteka, prenos (931,68 KB)
MD5: 08631684864536E13B6E75254DD11CB6
URLURL - Izvorni URL, za dostop obiščite http://www.nature.com/articles/nenergy2016134 Povezava se odpre v novem oknu

Izvleček
A large fraction of global energy use is for refrigeration and air-conditioning, which could be decarbonized if efficient renewable energy technologies could be found. Vapour-compression technology remains the most widely used system to move heat up the temperature scale after more than 100 years; however, caloric-based technologies (those using the magnetocaloric, electrocaloric, barocaloric or elastocaloric effect) have recently shown a significant potential as alternatives to replace this technology due to high efficiency and the use of green solid-state refrigerants. Here, we report a regenerative elastocaloric heat pump that exhibits a temperature span of 15.3 K on the water side with a corresponding specific heating power up to 800W1/kg and maximum COP (coefficient-of-performance) values of up to 7. The efficiency and specific heating power of this device exceeds those of other devices based on caloric effects. These results open up the possibility of using the elastocaloric effect in various cooling and heat-pumping applications.

Jezik:Angleški jezik
Ključne besede:elastocaloric effect, regenerative thermodynamic cycle, heat pumps
Vrsta gradiva:Članek v reviji
Tipologija:1.01 - Izvirni znanstveni članek
Organizacija:FS - Fakulteta za strojništvo
Status publikacije:Objavljeno
Različica publikacije:Recenzirani rokopis
Leto izida:2016
Št. strani:Str. 1-6
Številčenje:Vol. 1, iss. 10, art. 16134
PID:20.500.12556/RUL-127890 Povezava se odpre v novem oknu
UDK:697:621.577(045)
ISSN pri članku:2058-7546
DOI:10.1038/nenergy.2016.134 Povezava se odpre v novem oknu
COBISS.SI-ID:14935067 Povezava se odpre v novem oknu
Datum objave v RUL:28.06.2021
Število ogledov:3688
Število prenosov:1050
Metapodatki:XML DC-XML DC-RDF
:
TUŠEK, Jaka, ENGELBRECHT, Kurt, ERIKSEN, Dan, DALLʹOLIO, Stefano, TUŠEK, Janez in PRYDS, Nini, 2016, A regenerative elastocaloric heat pump. Nature energy [na spletu]. 2016. Vol. 1, no. 10,  16134, p. 1–6. [Dostopano 30 marec 2025]. DOI 10.1038/nenergy.2016.134. Pridobljeno s: https://repozitorij.uni-lj.si/IzpisGradiva.php?lang=slv&id=127890
Kopiraj citat
Objavi na:Bookmark and Share

Gradivo je del revije

Naslov:Nature energy
Skrajšan naslov:Nat. energy
Založnik:Nature Publishing Group
ISSN:2058-7546
COBISS.SI-ID:14934811 Povezava se odpre v novem oknu

Sekundarni jezik

Jezik:Slovenski jezik
Ključne besede:elastokalorični učinek, regenerativni termodinamični krožni proces, toplotne črpalke

Projekti

Financer:Drugi - Drug financer ali več financerjev
Program financ.:DTU’s international H.C. Ørsted postdoctoral programm
Naslov:Design and testing of an efficient elastocaloric refrigerator for room-temperature applications

Financer:ARRS - Agencija za raziskovalno dejavnost Republike Slovenije
Številka projekta:Z2-7219
Naslov:Od elastokaloričnega efekta do učinkovite hladilne naprave

Podobna dela

Podobna dela v RUL:
  1. effect of heat treatment on mechanical properties and microstructure of EN AW-7075 alloy
  2. influence of heat treatment on mechanical properties of alloy EN AW 5051A
  3. Influence on heat treatment on mechanical properties of fir
  4. influence of heat treatment process on microstructure and mechanical properties of martensitic stainless steel X20Cr13
  5. mechanical properties and microstructure of martensitic stainless steels 08X14NDL and GX4CrNi13-4
Podobna dela v drugih slovenskih zbirkah:
  1. Effect of heat treatment on the properties of tool steel
  2. The effect of heat treatment on the interface of 155 PH martensitic stainless steel and SAF 2507 duplex steel in functionally graded AM components

Nazaj