Selection of the most suitable material handling system in production

Berlec, Tomaž (avtor), Tanšek, Blaž (avtor), Kušar, Janez (avtor)

When building a new company or optimising an existing one, material handling (MH) is often forgotten. Therefore, the paper presents a decision tree, on the basis of which it is possible to select the most suitable MH system by simulation depending on the selected production parameters. Such a simulation can greatly facilitate the selection of the most suitable MH system which will ensure minimal time consumption and still acceptable costs. To perform the simulation, a generalised production system model for 5 different MH systems was created in the FlexSim software, with which 32 different scenarios could be simulated depending on the selected production parameters, tested in a production facility of injection moulded components for the automotive industry. The data obtained from the simulations were then used to analyse the influence of the selected parameters on possible MH systems. For all potential scenarios, the solutions of which are acceptable for MH, a cost-benefit analysis was performed. Based on the analysis, a difference of 75 % between the most and least favourable scenarios was established.

• Jezik: Angleški jezik
• Ključne besede: production, material handling systems, simulation, optimisation, cost-benefit analysis
• Vrsta gradiva: Članek v reviji
• Tipologija: 1.01 - Izvirni znanstveni članek
• Organizacija: FS - Fakulteta za strojništvo
• Status publikacije: Objavljeno
• Različica publikacije: Objavljena publikacija
• Leto izida: 2021
• Št. strani: Str. 64-75
• Številčenje: Vol. 20, no. 1
• PID: 20.500.12556/RUL-125233
• UDK: 658.2/.5(045)
• ISSN pri članku: 1726-4529
• DOI: 10.2507/IJSIMM20-1-542
• COBISS.SI-ID: 54449411
• Datum objave v RUL: 09.03.2021

BERLEC, Tomaž, TANŠEK, Blaž in KUŠAR, Janez, 2021, Selection of the most suitable material handling system in production. International journal of simulation modelling [na spletu]. 2021. Vol. 20, no. 1, p. 64–75. [Dostopano 17 april 2025]. DOI 10.2507/IJSIMM20-1-542. Pridobljeno s: https://repozitorij.uni-lj.si/IzpisGradiva.php?lang=slv&id=125233

Gradivo je del revije

• Naslov: International journal of simulation modelling
• Skrajšan naslov: Int. j. simul. model.
• Založnik: DAAAM International Vienna
• ISSN: 1726-4529
• COBISS.SI-ID: 8008982

Sekundarni jezik

• Jezik: Slovenski jezik
• Ključne besede: proizvodnja, rokovanje z materialom, simulacija, optimizacija, analiza koristi, analiza stroškov

Projekti

• Financer: Drugi - Drug financer ali več financerjev
• Program financ.: Ministrstvo za izobraževanje znanost in šport
• Številka projekta: P2-0270
• Naslov: Proizvodni sistemi, laserske tehnologije in spajanje materialov