Curling failure typically appears in bolted connections with thin plates, where the force is transferred by bolt bearing. The curling phenomena is related to the high compressive stresses caused by bolt bearing, which cause the plates to buckle, reducing the bearing strength of connections. Since the reduction of the bearing strength due to curling is not considered in design codes, the curling phenomenon has been studied numerically to understand the mechanical behaviour and to develop simple design rules that take into account the reduction in bearing strength. The reduction factor was developed taking into account the Eurocode approach, i.e. by calculating the elastic critical force associated to curling and the associated relative slenderness. Therefore, the elastic critical force in relation to curling was obtained by parametric buckling analysis in finite element software Abaqus. These results were used to develop a simple analytical model for the calculation of the elastic critical curling force. The reduction factor was obtained from the relationship between the results of the parametric GMNIA and the relative slenderness. The strength of single bolt lap connections was determined by geometrical and material nonlinear analysis with imperfections (GMNIA) considering various parameters, namely ratio of the bolt diameter to plate thickness, end distance e1, edge distance e2, material grade (S235, S690), amplitude of imperfections and boundary conditions. The accuracy of the reduction factor for bearing strength is checked on the basis of experimental data given in the literature.
|
