Mehanska analiza vpenjala za vpetje ulitka

Kopač, Miha (avtor), Mole, Nikolaj (mentor)

Izvedena je bila trdnostna in frekvenčna analiza obstoječe vpenjalne naprave z varjenimi spoji in modificirane vpenjalne naprave z vijačnimi spoji. Ker je vpenjalna naprava geometrijsko kompleksen sestav, je bil izdelan poenostavljeni geometrijski model sestava. Analizirani so bili obremenitveni pogoji v fazi mehanske obdelave in določeni robni pogoji, ki so upoštevani v numeričnem modelu. Trdnostna in frekvenčna analiza je bila izvedena po metodi končnih elementov v programskem okolju ABAQUS. Ker varjena izvedba vpenjala izpolnjuje togostne zahteve, so bili rezultati analize vijačene izvedbe primerjani z rezultati analize varjene izvedbe. Primerjava obeh izvedb pokaže ustreznost modificirane izvedbe vpenjala z vijačnimi spoji.

• Jezik: Slovenski jezik
• Ključne besede: togost konstrukcije, mehanska simulacija, metoda končnih elementov, programsko okolje ABAQUS, frekvenčna analiza
• Vrsta gradiva: Diplomsko delo/naloga
• Tipologija: 2.11 - Diplomsko delo
• Organizacija: FS - Fakulteta za strojništvo
• Kraj izida: Ljubljana
• Založnik: [M. Kopač]
• Leto izida: 2019
• Št. strani: XXIV, 46 str.
• PID: 20.500.12556/RUL-109673
• UDK: 621.74:62-229.31:519.61(043.2)
• COBISS.SI-ID: 16858907
• Datum objave v RUL: 06.09.2019

Sekundarni jezik

• Jezik: Angleški jezik
• Naslov: Mechanical analysis of clamps for clamping castings

Izvleček

A strength and frequency analysis of the existing clamping device with welded joints and a modified clamping device with screw joints was performed. As the clamping device is a geometrically complex assembly, a simplified geometric model of the assembly was made. The load conditions in the mechanical treatment phase and certain boundary conditions that are taken into account in the numerical model, were analysed. The strength and frequency analysis was performed using the finite element method in ABAQUS. Since the welded version of the clamp meets the stiffness requirements, the results of the analysis of the screwed version were compared with the results of the welded-assay analysis. A comparison of both versions shows the relevance of the modified version of the clamp with screw joints.

• Ključne besede: design stiffness, mechanical simulation, finite element method, ABAQUS software, frequency analysis