Analiza obdelovalnosti bakrove zlitine pri procesu mikro frezanja

Debevec, Timotej (avtor), Pušavec, Franci (mentor), Kopač, Janez (komentor)

V diplomskem delu je zajet pregled znanstvene literature na področju frezanja, mikrofrezanja in rezalnih materialov ter obdelovalnost bakra in bakrovih zlitin. Predstavljena je problematika mikroobdelav in nedoseganja zahtevanih hrapavosti obdelane površine. Opisano je eksperimentalno mesto za izvedbo eksperimentov. V eksperimentalnem delu smo poskušali doseči zahtevano hrapavost površine pri frezanju bakrove zlitine. Do zahtevane hrapavosti površine smo najprej poskušali priti z izbiro rezalnega materiala. Od rezalnega orodja smo nadaljevali do analize obdelovalnih strategij. Kot rezultat dela smo predstavili ugotovitev, da postopki mikrofrezanja prinašajo številne prednosti konvencionalnim strategijam obdelave, ne le v smislu geometrijske natančnosti, pač pa tudi kakovosti obdelanih površin.

• Jezik: Slovenski jezik
• Ključne besede: frezanje, mikrofrezanje, bakrove zlitine, rezalni materiali, hrapavost površine
• Vrsta gradiva: Diplomsko delo/naloga
• Organizacija: FS - Fakulteta za strojništvo
• Leto izida: 2018
• PID: 20.500.12556/RUL-100836
• Datum objave v RUL: 18.04.2018

DEBEVEC, Timotej, 2018, Analiza obdelovalnosti bakrove zlitine pri procesu mikro frezanja [na spletu]. Diplomsko delo. [Dostopano 28 marec 2025]. Pridobljeno s: https://repozitorij.uni-lj.si/IzpisGradiva.php?lang=slv&id=100836

Sekundarni jezik

• Jezik: Angleški jezik
• Naslov: The analysis of the machiniability of copper alloys with the process of micromilling

Izvleček

The thesis encompasses an overview of scientific literature in the scope of milling, micromilling and cutting materials as well as machinability of copper and copper alloys. The problem of micro machinability and the failure in reaching the required surface roughness is presented. The experimental side where the experiments were conducted is described. In the experimental part, attempts to reach the required surface roughness with the milling of copper alloys were made. First it was attempted to achieve the required surface roughness with the choice of cutting material, continuing with the analysis of the machining strategies. The presented results showed that the process of micromilling has several advantages, compared to the conventional machining strategies, not only because of its geometric precision, but also in the quality of the processed surfaces.

• Ključne besede: milling, micromilling, copper alloys, cutting materials, surface roughness