izpis_h1_title_alt

A method for optimal blank shape determination in sheet metal forming based on numerical simulations
Mole, Nikolaj (Avtor), Cafuta, Gašper (Avtor), Štok, Boris (Avtor)

URLURL - Predstavitvena datoteka, za dostop obiščite http://www.dlib.si/details/URN:NBN:SI:doc-PNWU47KZ Povezava se odpre v novem oknu

Izvleček
The main benefit in using optimally shaped blanks in sheet metal forming is in maximizing the efficiency of the forming process and, since there is no need for additional cutting operations after the finished forming operation, in substantial reduction of the overall production cost. The paper presents a numerical method for optimal blank shape determination which is suitable in various sheet metal forming applications. The optimal blank shape is determined in iterative way so that the edge geometry of the formed product fits its reference geometry as close as possible. The iterative process starts at blank shape from which the product is produced with its edge fitting its reference geometry just approximately. In subsequent iterations the blank shape is continuously improved in accordance with the developed optimisation method. In order to determine the product edge geometry resulting from the current blank shape, a computer simulation of the forming process and the springback is performed in each iteration. Since its effectiveness highly depends on the quality and physical objectivity of the computer simulation, the developed numerical blank shape optimisation procedure has been validated also experimentally by considering forming of a product with rather complex edge geometry as the case study.

Jezik:Angleški jezik
Ključne besede:sheet metal forming, blank shape optimisation, springback compensation
Vrsta gradiva:Delo ni kategorizirano (r6)
Tipologija:1.01 - Izvirni znanstveni članek
Organizacija:FS - Fakulteta za strojništvo
Leto izida:2013
Št. strani:str. 237-250, SI 44
Številčenje:Vol. 59, no. 4
UDK:621.9
ISSN pri članku:0039-2480
DOI:10.5545/sv-jme.2012.989 Povezava se odpre v novem oknu
COBISS.SI-ID:12737819 Povezava se odpre v novem oknu
Število ogledov:983
Število prenosov:290
Metapodatki:XML RDF-CHPDL DC-XML DC-RDF
 
Skupna ocena:(0 glasov)
Vaša ocena:Ocenjevanje je dovoljeno samo prijavljenim uporabnikom.
:
Objavi na:AddThis
AddThis uporablja piškotke, za katere potrebujemo vaše privoljenje.
Uredi privoljenje...

Gradivo je del revije

Naslov:Strojniški vestnik
Skrajšan naslov:Stroj. vestn.
Založnik:Zveza strojnih inženirjev in tehnikov Slovenije [et al.], = Association of Mechanical Engineers and Technicians of Slovenia [et al.]
ISSN:0039-2480
COBISS.SI-ID:762116 Povezava se odpre v novem oknu

Sekundarni jezik

Jezik:Slovenski jezik
Ključne besede:preoblikovanje pločevine, optimiranje začetne oblike pločevine, kompenzacija elastične povračljivosti

Podobna dela

Podobna dela v RUL:
Podobna dela v drugih slovenskih zbirkah:

Komentarji

Dodaj komentar

Za komentiranje se morate prijaviti.

Komentarji (0)
0 - 0 / 0
 
Ni komentarjev!

Nazaj