izpis_h1_title_alt

Detecting groan sources in drum brakes of commercial vehicles by TVA-FMEA : a case study
Karabay, Sedat (Avtor), Baynal, Kasim (Avtor), İğdeli, Cengiz (Avtor)

URLURL - Predstavitvena datoteka, za dostop obiščite http://www.dlib.si/details/URN:NBN:SI:doc-CU0RMHGL Povezava se odpre v novem oknu

Izvleček
In this article, the strategy followed by an automobile company for detecting the root causes of groan complaints related to rear drum brakes in commercial vehicles is presented using data collected from the sold troubled vehicles and from new vehicles from the production line, as well as the drum-brake test rig at the laboratory. Drum brake groan is often very intense and can cause large numbers of customer complaints. During a groan noise event, vehicle structure and suspension components are excited by the brake system and result in a violent event that can be heard and felt during brake application. This paper condenses experimental studies on a low frequency drum brake groan problem that has caused high warranty costs. First, the environmental conditions causing the groan were identified and the groan was reproduced. Vehicle tests were performed both at the factory and in traffic. To conclude the planned study, TVA (Total Value Analysis) and FMEA (Failure Mode and Effects Analysis) methods were used effectively. A strategy to determine the root causes was planned and implemented systematically to eliminate the secondary and tertiary effects of brake groan problems. In order to ge to the root causes, vibration and groan measurements were executed and interpreted according to TVA and FMEA charts. The sensitivity of the lining material of the brake shoes to different environmental conditions was investigated. Finally, the groan mechanism of the drum brake system is discussed and the solution to the low frequency drum brake groan problem is evaluated in detail.

Jezik:Angleški jezik
Ključne besede:drum brake, TVA, FMEA, NVH, friction coefficient, brake groan, brake lining
Vrsta gradiva:Delo ni kategorizirano (r6)
Tipologija:1.01 - Izvirni znanstveni članek
Organizacija:FS - Fakulteta za strojništvo
Leto izida:2013
Št. strani:str. 375-386, SI 70
Številčenje:Vol. 59, no. 6
UDK:629.3.02:62-597.6
ISSN pri članku:0039-2480
DOI:10.5545/sv-jme.2012.809 Povezava se odpre v novem oknu
COBISS.SI-ID:13074459 Povezava se odpre v novem oknu
Število ogledov:529
Število prenosov:164
Metapodatki:XML RDF-CHPDL DC-XML DC-RDF
 
Skupna ocena:(0 glasov)
Vaša ocena:Ocenjevanje je dovoljeno samo prijavljenim uporabnikom.
:
Objavi na:AddThis
AddThis uporablja piškotke, za katere potrebujemo vaše privoljenje.
Uredi privoljenje...

Gradivo je del revije

Naslov:Strojniški vestnik
Skrajšan naslov:Stroj. vestn.
Založnik:Zveza strojnih inženirjev in tehnikov Slovenije [et al.], = Association of Mechanical Engineers and Technicians of Slovenia [et al.]
ISSN:0039-2480
COBISS.SI-ID:762116 Povezava se odpre v novem oknu

Sekundarni jezik

Jezik:Slovenski jezik
Ključne besede:bobnasta zavora, TVA, FMEA, NVH, koeficient trenja, ječanje zavor, zavorne obloge

Podobna dela

Podobna dela v RUL:
Podobna dela v drugih slovenskih zbirkah:

Komentarji

Dodaj komentar

Za komentiranje se morate prijaviti.

Komentarji (0)
0 - 0 / 0
 
Ni komentarjev!

Nazaj