izpis_h1_title_alt

Time-dependent constitutive modeling of drive belts - I. : the effect of geometry and number of loading cycles
Emri, Igor (Avtor), Kramar, Janez (Avtor), Hribar, Anton (Avtor), Nikonov, Anatolij (Avtor), Florjančič, Urška (Avtor)

URLURL - Predstavitvena datoteka, za dostop obiščite http://dx.doi.org/10.1007/s11043-006-9021-2 Novo okno

Izvleček
This paper presents constitutive modeling of dynamically loaded elastomeric products such as power transmission belts. During the normal operation of the belts certain segments of the belt structure are loaded with a tooth-like periodic (cyclic) loading. When the time-dependent properties of the elastomeric material "match" the time-scale of the dynamic loading a strain accumulation process occurs. The critical angular velocity is proportional to the ratio of the belt length to the common diameters of the pulleys. The magnitude of the strain accumulated in each loading cycle decreases with an increase in belt length. For a given belt geometry the critical angular velocity increases with the number of loading cycles. At the same time the magnitude of the accumulated strain decreases non-linearly as the number of loading cycles increases. However if the belt operates at or in the close vicinity of its critical angular velocity it will almost certainly fail! The critical angular velocity depends on the material retardation time (location in the frequency spectrum), while the magnitude of the accumulated strain is dictated by the strength of the corresponding discrete spectrum lines. Thus, the mechanical spectrum of the elastomeric material from which the belt is constructed is the most important material function for predicting the durability of drive belts and similarly dynamically loaded elastomeric products.

Jezik:Angleški jezik
Ključne besede:pogonski jermeni, časovno odvisni materiali, napake, viskoelastičnost, analize, napetosti-deformacije, elastomeri, kompoziti, time-dependent constitutive modeling, power transmission belts, drive belts, synchronous belts, failure, viskoelastic analysis, stress-strain accumulation
Vrsta gradiva:Delo ni kategorizirano (r6)
Tipologija:1.01 - Izvirni znanstveni članek
Organizacija:FS - Fakulteta za strojništvo
Leto izida:2006
Št. strani:str. 245-262
Številčenje:Letn. 10, št. 3
UDK:621.852:678
ISSN pri članku:1385-2000
COBISS.SI-ID:9871387 Povezava se odpre v novem oknu
Število ogledov:479
Število prenosov:166
Metapodatki:XML RDF-CHPDL DC-XML DC-RDF
 
Skupna ocena:(0 glasov)
Vaša ocena:Ocenjevanje je dovoljeno samo prijavljenim uporabnikom.
:
Objavi na: Bookmark and Share

Gradivo je del revije

Naslov:Mechanics of time-dependent materials
Skrajšan naslov:Mech. time-depend. mater.
Založnik:Kluwer
ISSN:1385-2000
COBISS.SI-ID:3749403 Novo okno

Podobna dela

Podobna dela v RUL:
Podobna dela v drugih slovenskih zbirkah:

Komentarji

Dodaj komentar

Za komentiranje se morate prijaviti.

Komentarji (0)
0 - 0 / 0
 
Ni komentarjev!

Nazaj