izpis_h1_title_alt

Machinability of 90MnCrV8 steel during high-speed machining
Ekinović, Sabahudin (Avtor), Dolinšek, Slavko (Avtor), Begović, Edin (Avtor)

URLURL - Predstavitvena datoteka, za dostop obiščite http://dx.doi.org/10.1016/j.jmatprotec.2005.02.178 Novo okno

Izvleček
The paper presents some investigation regarding term "machinability" of materials at different cutting conditions. The very same material may shows different behavior when it is cut at for example conventional conditions then at high-speed cutting conditions. The author's intention was to find how wouldreaction of some steel with, for conventional cutting conditions, good machinability, look like in slightly changed cutting conditions. Investigation was performed on following material - steel 90MnCrV8 - DIN, known as material that has a "good machinability". Cutting conditions as well as workpiece properties (primarily hardness) were set to enclose transition region from conventional to high-speed machining [Ekinović, Dolinšek]. Machined surface quality has been choose as measure of machinability.

Jezik:Angleški jezik
Ključne besede:machinability, high-speed cutting, chip shape
Vrsta gradiva:Delo ni kategorizirano (r6)
Tipologija:1.01 - Izvirni znanstveni članek
Organizacija:FS - Fakulteta za strojništvo
Leto izida:2005
Št. strani:str. 603-608
Številčenje:Letn. 162/163
UDK:621.9
ISSN pri članku:0924-0136
COBISS.SI-ID:8146971 Povezava se odpre v novem oknu
Število ogledov:495
Število prenosov:133
Metapodatki:XML RDF-CHPDL DC-XML DC-RDF
 
Skupna ocena:(0 glasov)
Vaša ocena:Ocenjevanje je dovoljeno samo prijavljenim uporabnikom.
:
Objavi na: Bookmark and Share

Gradivo je del revije

Naslov:Journal of materials processing technology
Skrajšan naslov:J. mater. process. technol.
Založnik:Elsevier
ISSN:0924-0136
COBISS.SI-ID:30105600 Novo okno

Podobna dela

Podobna dela v RUL:
Podobna dela v drugih slovenskih zbirkah:

Komentarji

Dodaj komentar

Za komentiranje se morate prijaviti.

Komentarji (0)
0 - 0 / 0
 
Ni komentarjev!

Nazaj