izpis_h1_title_alt

Tool wear monitoring during the turning process
Kopač, Janez (Avtor), Šali, Samo (Avtor)

URLURL - Predstavitvena datoteka, za dostop obiščite http://www.elsevier.nl/cdweb/journals/09240136/viewer.htt?iss=1-3&vol=113 Povezava se odpre v novem oknu

Izvleček
The aim of the present research was to build a simple model for tool wear monitoring during the machining process. In addition, by this model a prediction of tool wear for a variety of different cutting speeds and feed rates should be possible. Therefore, the sound pressure at 0.5 m from the cutting zone during the turning was measured by a condenser microphone and analysed in frequency domain from 0 to 22 kHz. The measurement arrangement as well as the possibilities for on-line sensing of the tool wear are presented. The workpiece material was carbon steel Ck15 (DIN) and the cutting insert was made of cermet without coating. The depth of cut was the constant, whereas the cutting speed, feed rate and flank wear of the tool were variables. The results showed that an increase in tool wear correlates with an increase in the amplitude of the recorded sound between 6 and 20 kHz. Similarly, an increase in feed rate resulted in an increase of sound intensity between 2 and 19 kHz. In contrast with these findings, the cutting speed influenced the recorded signals considerably less. It can be concluded that under the given circumstances the monitoring of tool wear by the sound emitted is a possible and relatively simple method.

Jezik:Angleški jezik
Ključne besede:turning processes, noise, tool wear, cutting speed, feed rate
Vrsta gradiva:Delo ni kategorizirano (r6)
Tipologija:1.01 - Izvirni znanstveni članek
Organizacija:FS - Fakulteta za strojništvo
Leto izida:2001
Št. strani:str. 312-316
Številčenje:Vol. 113, no. 1/3, special issue "5th APCMP, Seoul, Korea"
UDK:621.9
ISSN pri članku:0924-0136
COBISS.SI-ID:4431643 Povezava se odpre v novem oknu
Število ogledov:747
Število prenosov:283
Metapodatki:XML RDF-CHPDL DC-XML DC-RDF
 
Skupna ocena:(0 glasov)
Vaša ocena:Ocenjevanje je dovoljeno samo prijavljenim uporabnikom.
:
Objavi na:AddThis
AddThis uporablja piškotke, za katere potrebujemo vaše privoljenje.
Uredi privoljenje...

Gradivo je del revije

Naslov:Journal of materials processing technology
Skrajšan naslov:J. mater. process. technol.
Založnik:Elsevier
ISSN:0924-0136
COBISS.SI-ID:30105600 Povezava se odpre v novem oknu

Podobna dela

Podobna dela v RUL:
Podobna dela v drugih slovenskih zbirkah:

Komentarji

Dodaj komentar

Za komentiranje se morate prijaviti.

Komentarji (0)
0 - 0 / 0
 
Ni komentarjev!

Nazaj