izpis_h1_title_alt

Sorptive stress estimation: an important key to the mechano-sorptive effect in wood
Houška, Mladen (Avtor), Koc, Pino (Avtor)

URLURL - Predstavitvena datoteka, za dostop obiščite http://dx.doi.org/10.1023/A:1009897822196 Novo okno

Izvleček
The mechano-sorptive effect (MSE) can be classified as a very interesting, but not yet completely explained phenomenon of wood behaviour. We therefore decided to try to discover its most relevant mechanisms, by conducting two independent series of measurements: accurate measurements of bending deflections on small, clear specimens of spruce wood in changeable climate conditions; and average moisture content (MC) in three parts of the cross-section of unloaded dummy samples. The paper emphasises on the sorptive part of MSE. A computer simulation of the wetting experiment is done to determine the space and time-dependent MC field in the cross-section of the sample. Using a so-called inverse problem identification method, where the equivalence of the computed and measured responses of the numerical model and real sample is imposed, we identified unknown material properties. The solution of the inverse problem enabled us simultaneously to estimate the moisture diffusion coefficients and to determine the MC field. Two kinds of boundary conditions were used in simulations. To estimate the magnitude of sorption stresses a numerical analysis using Finite Element Method (FEM) was done. The sorptive stresses resulting from the nonhomogeneous MC distribution in the sample were obtained. The decisive factor is the gradient of moisture content and resulting sorptive stresses must be taken into account because their magnitude is of the same order as the load induced bending stresses. Our experiments and the calculations following enabled us to conclude that the reason for MS behaviour could be the simultaneous action of permanent load stresses and the transient triaxial sorptive stress state.

Jezik:Angleški jezik
Ključne besede:mehanika, obnašanje lesa, mehano-sorptivni učinek, sorptivna napetost, nestacionarni vlažnostni gradienti, mechanics, wood behaviour, sorptive stresses, changeable moisture content, inverse identification method, mechano-sorptive effect, MSE, numerical simulation
Vrsta gradiva:Delo ni kategorizirano (r6)
Tipologija:1.01 - Izvirni znanstveni članek
Organizacija:FS - Fakulteta za strojništvo
Leto izida:2000
Št. strani:str. 81-98
Številčenje:Vol. 4, no. 1
UDK:691.11:539.3
ISSN pri članku:1385-2000
COBISS.SI-ID:3749659 Povezava se odpre v novem oknu
Število ogledov:483
Število prenosov:156
Metapodatki:XML RDF-CHPDL DC-XML DC-RDF
 
Skupna ocena:(0 glasov)
Vaša ocena:Ocenjevanje je dovoljeno samo prijavljenim uporabnikom.
:
Objavi na: Bookmark and Share

Gradivo je del revije

Naslov:Mechanics of time-dependent materials
Skrajšan naslov:Mech. time-depend. mater.
Založnik:Kluwer
ISSN:1385-2000
COBISS.SI-ID:3749403 Novo okno

Podobna dela

Podobna dela v RUL:
Podobna dela v drugih slovenskih zbirkah:

Komentarji

Dodaj komentar

Za komentiranje se morate prijaviti.

Komentarji (0)
0 - 0 / 0
 
Ni komentarjev!

Nazaj