20.500.12556/RUL-94955 Napenjalo folije pri DLP-stereolitografskem tiskalniku Foil tension device for DLP stereolithographic printer V zaključni nalogi je predstavljen postopek razvoja napenjala folije pri DLP-stereolitografskem tiskalniku. Ena izmed večjih težav tiskalnikov, pri katerih osvetljujemo od spodaj, je napenjanje folije na dnu bazena, saj je folijo zelo težko pritrditi in napeti, ne da bi jo pri tem poškodovali. Hkrati moramo zagotoviti popolno paralelnost med dnom bazena in mizico, na kateri nastaja izdelek. Izdelali smo napenjalo folije, ki smo ga testirali na dveh različno debelih folijah in ugotovili, da napenjalo deluje v skladu s pričakovanji. In the thesis, the development of foil tension device for DLP stereolithographic printer is presented. One of the most common problems of the printers with the light source mounted below the vat is the tension of the foil on the bottom of the vat. It is difficult to fix and stretch the foil without damaging it. At the same time we have to provide the perfect parallelism between bottom of the vat and the place where the product is formed. Foil tension device was created and tested using foils of two different thicknesses. We found out that device is working properly. 3D-tiskanje stereolitografija bazen s fotopolimerom napenjalo folija 3D printing stereolithography vat with photopolimer tension device foil true false false Slovenski jezik Angleški jezik Diplomsko delo/naloga 2017-09-11 13:34:56 2017-09-11 13:34:56 2022-08-10 02:08:11 0000-00-00 00:00:00 2017 0 0 0000-00-00 NiDoloceno NiDoloceno NiDoloceno 0000-00-00 0000-00-00 0000-00-00 1970-01-01 200066 878.pdf 878.pdf 1 ACE15B6592C5503805CBAAA85571C6A6 912383518b755d177e74e6f121cf57eb1e04f5b806bc5fb20046e672e1106032 a51dc06b-a1b3-11eb-a523-00155dcfd717 20.500.12556/rul/45869f65-8161-422f-8b3c-89df2b6c0235 https://repozitorij.uni-lj.si/Dokument.php?lang=slv&id=103444 Fakulteta za strojništvo 0 0 0