20.500.12556/RUL-73718 Influence of tool wear on the quality of newly formed surface in the drilling of wood composites The geometry of a drilling tool largely affects the quality of the newly formed surface. When drilling through a composite panel, the hole edge quality on the outlet side is significantly worse than on the inlet side, so the choice of the appropriate tool geometry is crucial. Even if the tool geometry is correct, tool wear also has a strong influence on the quality of the newly formed surface of the holes. With the tool wear, the force in the direction of drilling and torque around the axis of drilling are increasing which can affect to the delamination of particle board on the outlet side. The proposed model for hole edge quality prediction on the outlet side was tested on an experimental model where the cutting forces and torque in the drilling direction were measured, and the quality of the newly formed surfaces was evaluated every 180 holes using a visual method. vrtanje rezalne sile vlaknena plošča površina delaminacija drilling cutting forces particle board surface delamination quality of the edge true false false Angleški jezik Neznan jezik Delo ni kategorizirano 2015-12-01 05:33:30 2015-12-01 05:33:32 2022-08-01 18:23:18 0000-00-00 00:00:00 2013 0 0 Str. 29-33 0000-00-00 NiDoloceno NiDoloceno NiDoloceno 0000-00-00 0000-00-00 0000-00-00 621.9 2151817 2150281 gprnik_Proceedings_AMBIENTA_2013.pdf gprnik_Proceedings_AMBIENTA_2013.pdf 1 9B4B527DCB0CDDCE30B24A4DEA6C06B5 4bf1452b5c4bda0aa3de545ce18c5384f6a6cf12936357109bc1d86b8fc47f3d 6d40e52b-a1b3-11eb-a523-00155dcfd717 20.500.12556/rul/8f46e139-c73f-4208-8140-c91e3b869d70 https://repozitorij.uni-lj.si/Dokument.php?lang=slv&id=100918 Biotehniška fakulteta 0 0 0