20.500.12556/RUL-187036 Two-surface slip in EHL contacts influence on film thickness and friction This work examines symmetric shear-limited slip at the two fluid–solid interfaces in a fully flooded, isothermal elastohydrodynamic line contact using a fully coupled Navier–Stokes and elastic deformation framework. This formulation computes the velocity field and wall shear rate directly, allowing straight identification of the slip start position and the slip-active zone, which cannot be resolved unequivocally with Reynolds-based models. Unlike earlier single-surface or limiting shear stress approaches, this study resolves the slip start position and the associated active zone relative to the Hertzian contact. The study establishes the mechanical conditions under which slip reduces the friction while either reducing or preserving the film thickness and quantifies the influence of the slip yield stress and the slip length on the evolution of the wall shear rate and the wall shear stress across the contact. Slip initiated before the Hertzian contact lowers the effective entrainment velocity, which reduces the film thickness. The largest friction reduction occurs when the mean slip start position is located near the Hertzian contact half-width, where the slip weakens the viscous resistance inside the high-pressure region with only a minor influence on the inlet flow. When the slip is confined to the Hertzian contact, the film thickness remains unchanged, and friction reductions up to 48% are obtained. Increasing the slip length continuously reduces the wall shear stress and thereby the friction until the fluid layer adjacent to the interface approaches the far-field fluid velocity in the film. fluid–solid interaction elastohydrodynamic lubrication slip conditions coefficient of friction film thickness optimisation interakcije trdno-tekoče elastohidrodinamično mazanje pogoji zdrsa koeficient trenja optimizacija debeline filma true false true Angleški jezik Slovenski jezik Članek v reviji 2026-09-08 13:36:26 2026-09-08 13:36:32 2026-09-09 04:22:27 0000-00-00 00:00:00 2026 0 0 15 str. Vol. 221, art. 112047 2026 0000-00-00 Zaloznikova Objavljeno NiDoloceno 0000-00-00 0000-00-00 0000-00-00 539.92:621.89 0301-679X 10.1016/j.triboint.2026.112047 290391043 Ajeeb_..._Two.surface....pdf Ajeeb_..._Two.surface....pdf 1 8318D8B06BE2C4BB83E3959FDF504234 eebf268055483e4f36fdeeb2848529e733aca011b8ec6416ac6696c7cf884640 c2165123-ab79-11f1-8bc5-0050569b8976 https://repozitorij.uni-lj.si/Dokument.php?lang=slv&id=246469 https://www.sciencedirect.com/science/article/pii/S0301679X26003907 1 86738b71-ab79-11f1-8bc5-0050569b8976 https://repozitorij.uni-lj.si/Dokument.php?lang=slv&id=246468 Fakulteta za strojništvo 0 0 0