20.500.12556/RUL-116200 Control system for a tensile-testing device using low-cost hardware and open-source software Krmilni sistem naprave za natezne preizkuse z uporabo cenovno ugodne strojne opreme in odprtokodnega programja The aim of this study is to verify whether a Raspberry Pi 3 B+ can be utilized as a low-cost device for controlling a tensile-testing device used for material research purposes. A list of requirements based on already-available hardware was drawn up, which the new control system had to fulfil. To connect all the necessary equipment, a connection board was constructed, and some additional hardware was acquired for the system to be able to perform all the necessary tasks. The whole controlling system was also put in a small enclosure to make it portable. The control-system software was written in C++ using the Pigpio library. The developed system was then tested, and the results were compared to a commercially available Instron 8802 device. A comparison of the results shows that the upgraded equipment can produce comparable results to commercially available devices and is sufficiently accurate to be applied for research purposes for the characterization of soft tissues and other materials. Raspberry Pi low-cost tensile testing measuring equipment krmilni sistemi merilna oprema natezne naprave odprtokodno nizkocenovna strojna oprema true false true Angleški jezik Slovenski jezik Neznano 2020-05-22 08:51:34 2020-05-22 08:51:37 2023-11-29 10:54:01 0000-00-00 00:00:00 2020 0 0 Str. 155-163 iss. 3 Vol. 66 2020 0000-00-00 Zaloznikova Objavljeno NiDoloceno 0000-00-00 0000-00-00 0000-00-00 004.3:620.172(045) 0039-2480 10.5545/sv-jme.2019.6418 17170203 762116 RAZ_Kranjec_Matej_2020.pdf RAZ_Kranjec_Matej_2020.pdf 1 AEC82057511CDCB53067E7127F2E4E5A b70e04c5e2f2aa1b533916d1a5d708b10385da7c9ef00e64c46405f2769f263a d5fda5c5-a1b8-11eb-a523-00155dcfd717 https://repozitorij.uni-lj.si/Dokument.php?lang=slv&id=129618 https://www.sv-jme.eu/article/control-system-for-tensile-testing-device-using-low-cost-hardware-and-open-source-software/ 1 https://repozitorij.uni-lj.si/Dokument.php?lang=slv&id=129617 Fakulteta za strojništvo Strojniški vestnik 0 0 0