Energy density effect of laser alloyed TiB$_2$/TiC/Al composite coatings on LMZ/HAZ, mechanical and corrosion propertiesRavnikar, Dunja (Avtor) Trdan, Uroš (Avtor) Nagode, Aleš (Avtor) Šturm, Roman (Avtor) laser surface alloying (LSA)ceramic coatings on Al alloymicrostructurelaser melted/heat affected zone (LMZ/HAZ)microhardnesswearcorrosionIn the present work, TiC/TiB$_2$/Al composite coatings were synthesized onto a precipitation hardened AlSi1MgMn alloy by laser surface alloying (LSA), using 13.3 J/mm$^2$ and 20 J/mm$^2$ laser energy densities. Microstructure evaluation, microhardness, wear and corrosion performance were investigated and compared with the untreated/substrate Al alloy sample. The results confirmed sound, compact, crackles composite coating of low porosity, with a proper surface/substrate interface. Microstructural analyses revealed the formation of extremely fine nano-precipitates, ranging from of 50–250 nm in the laser melted (LMZ) and large precipitates, accompanied with grain coarsening in the heat-affected zone (HAZ), due to the substrate overheating during the LSA process. Nonetheless, both coatings achieved higher microhardness, with almost 7-times higher wear resistance than the untreated sample as a consequence of high fraction volume of hard, wear resistant TiB$_2$ and TiC phases inside the composite coatings. Further, cyclic polarization results in 0.5 M NaCl aqueous solution confirmed general improvement of corrosion resistance after LSA processed samples, with reduced corrosion current by more than a factor of 9, enhanced passivation/repassivation ability and complete prohibition of crystallographic pitting, which was detected with the untreated Al alloy.20202021-06-01 08:47:36Članek v reviji127266sl