Primerjava lastnosti lazur na toplotno modificiranem ali z biocidom zaščitenem smrekovem lesu : diplomsko delo (univerzitetni študij)

Kortnik, Matej (avtor), Petrič, Marko (mentor), Humar, Miha (recenzent)

Za zaščito lesa za zunanjo uporabo se pogosto uporabljajo površinska zaščitna sredstva, ki poudarjajo tudi dekorativne značilnosti lesa. Vendar za les, ki je izpostavljen vremenskim vplivom, zaščita s površinskimi premazi ponavadi ni zadostna. Vsaka predhodna obdelava lesa, kot sta npr. zaščita lesa z biocidi ali modifikacija lesa, lahko vpliva na lastnosti premazov, kakor tudi na procese staranja površinskih sistemov. V ta namen smo preučevali vpliv impregnacije in toplotne modifikacije substrata na prepustnost premazov za vodo, vodno paro in oprijemnost. Vremenske vplive na celoten sistem "podlaga-premaz" smo simulirali z umetno pospešenim staranjem. Rezultati so pokazali, da predhodna obdelava lesa z impregnacijo z biocidi in toplotno modifikacijo nima pomembnih negativnih vplivov na preučevane lastnosti, pač pa nekatere celo izboljša. Pri umetno pospešenem staranju je prišlo do nastanka napak na površini premazov, ki so bile najmanjše na sistemih "toplotno modificiran les-premaz", sledili pa so jim sistemi "impregniran les-premaz".

• Jezik: Slovenski jezik
• Ključne besede: površinska obdelava, premaz, toplotna modifikacija, biocid, Borosol, oprijemnost, permeabilnost, umetno pospešeno staranje
• Vrsta gradiva: Diplomsko delo
• Tipologija: 2.11 - Diplomsko delo
• Organizacija: BF - Biotehniška fakulteta
• Kraj izida: Ljubljana
• Založnik: [M. Kortnik]
• Leto izida: 2007
• Št. strani: X, 42 f.
• PID: 20.500.12556/RUL-215
• UDK: 630*829.17
• COBISS.SI-ID: 1516169
• Datum objave v RUL: 11.07.2014

KORTNIK, Matej, 2007, Primerjava lastnosti lazur na toplotno modificiranem ali z biocidom zaščitenem smrekovem lesu : diplomsko delo (univerzitetni študij) [na spletu]. Diplomsko delo. Ljubljana : M. Kortnik. [Dostopano 19 april 2025]. Pridobljeno s: https://repozitorij.uni-lj.si/IzpisGradiva.php?lang=slv&id=215

Sekundarni jezik

• Jezik: Angleški jezik
• Naslov: Coating performance comparison of heat or biocide treatet norway spruce wood : graduation thesis (university studies)

Izvleček

Wood products for exterior use are most commonly finished with surface coatings which highlight the decorative properties of wood. However, surface coatings do not provide sufficient protection to wood products that are exposed to weathering. But any pre-treatment of wood, such as impregnation with biocides or modification of wood, may affect the properties of coatings as well as resistance of surface systems against ageing. Therefore, the influence of impregnation and thermal modification of the substrate on water and water-vapour permeability as well as on adhesion was studied. Weathering was simulated on the "substrate-coating" systems with artificially accelerated ageing. It was shown by the results that biocide pre-treatment and thermal modification of wood did not have any important negative influences on the observed properties' some of the properties were even better. During artificially accelerated weathering some defects on the coatings' surfaces appeared which were the lowest in the case of the "thermally modified wood-coating" systems followed by the "impregnated wood-coating" ones.

• Ključne besede: surface treatment, coating, thermal modification, biocide, Borosol, adhesion, permeability, artificially accelerated aging