RILEM TC 277-LHS report : properties of lime-based renders and plasters—discussion of current test methods and proposals for improvement

Rosário Veiga, M. (avtor), Faria, Paulina (avtor), Hees, Rob P. J. van (avtor), Stefanidou, Maria (avtor), Maravelaki, Pagona Noni (avtor), Papayianni, Ioanna (avtor), Ioannou, Ioannis (avtor), Theodoridou, Magdalini (avtor), Bokan-Bosiljkov, Violeta (avtor), Bicer-Simsir, Beril (avtor), Tedeschi, Cristina (avtor), Carneiro, Arnaldo (avtor)

Renders and plasters have significant functions in buildings. Their functionality is closely related to their properties, which depend on the mortar itself, the application technology, the interaction with the environment and the substrate. There are many basic characteristics that influence the performance of renders and plasters; however, many of them are interrelated, thus the set of characteristics to be determined in each case is different, depending on the specific at each time use. These characteristics, their interrelations and the grouping of them are discussed and schematically described in the first and introductory section. Three groups are considered for renders and plasters: properties of fresh mortars; properties related to the hygric behaviour; and the mechanical behaviour. The properties of lime-based mortars measured in laboratory are highly affected by factors, such as: need of long time for development of representative values for prediction of their life-time behaviour, proper climatic conditions adequate for carbonation or/and hydration, sensitivity to the suction of water by the substrate. The last two factors—environment and substrate—have an important role for rendering and plastering with lime-based mortars, since both their exposed surfaces and the substrate areas they cover are large. Due to those specificities, the current test methods that have been mainly developed for cement-based mortars are not always fitted to characterize lime-based mortars, and in particular to assess lime-based renders and plasters. In section two the main characteristics and current standardized test methods are discussed based on experience in using them. Furthermore, needs of improvement are identified and changes are proposed, or, in some cases, new methods are outlined. Some of the most significant changes proposed are the possibility, as an option, to apply the mortar on a porous substrate, instead of moulding specimens in metallic moulds

• Jezik: Angleški jezik
• Ključne besede: civil engineering, render, plaster, lime, test, mechanical behaviour, hygric behavior, fresh state behavior
• Vrsta gradiva: Članek v reviji
• Tipologija: 1.02 - Pregledni znanstveni članek
• Organizacija: FGG - Fakulteta za gradbeništvo in geodezijo
• Leto izida: 2023
• Št. strani: 33 str.
• Številčenje: art. 70, vol. 56
• PID: 20.500.12556/RUL-146370
• UDK: 691
• ISSN pri članku: 1359-5997
• DOI: 10.1617/s11527-023-02141-9
• COBISS.SI-ID: 149825027
• Datum objave v RUL: 25.05.2023

Gradivo je del revije

• Naslov: Materials and structures
• Skrajšan naslov: Mat. struct.
• Založnik: E. & F. N. Spon, RILEM Publications
• ISSN: 1359-5997
• COBISS.SI-ID: 18240005

Sekundarni jezik

• Jezik: Slovenski jezik
• Ključne besede: gradbeništvo, zunanji omet, notranji omet, apno, preskušanje, mehanske lastnostni, prenos vlage, lastnosti v svežem stanju

Projekti

• Financer: ARRS - Agencija za raziskovalno dejavnost Republike Slovenije
• Številka projekta: P2-0185
• Naslov: Potresno inženirstvo