Calibration of advanced yield criteria using uniaxial and heterogeneous tensile test data

Maček, Andraž (avtor), Starman, Bojan (avtor), Mole, Nikolaj (avtor), Halilovič, Miroslav (avtor)

Conventionally, plastic anisotropy is calibrated by using standard uniaxial tensile and biaxial test results. Alternatively, heterogeneous strain field specimens in combination with full-field measurements can be used for this purpose. As reported by the literature, such an approach reduces the number of required tests enormously, but it is challenging to obtain reliable results. This paper presents an alternative methodology, which represents a compromise between the conventional and heterogeneous strain field calibration technique. The idea of the method is to use simple tests, which can be conducted on the uniaxial testing machine, and to avoid the use of advanced measuring equipment. The procedure is accomplished by conducting standard tensile tests, which are simple and reliable, and by a novel heterogeneous strain field tensile test, to calibrate the biaxial stress state. Moreover, only two of the parameters required for full characterisation need to be inversely identified from the test response; the other parameters are directly determined from the uniaxial tensile test results. This way, a dimension of optimization space is reduced substantially, which increases the robustness and effectiveness of the optimization algorithm.

• Jezik: Angleški jezik
• Ključne besede: plasticity, biaxial testing, numerical simulation, identification, full-field measurement, YLD2000-2d
• Vrsta gradiva: Članek v reviji
• Tipologija: 1.01 - Izvirni znanstveni članek
• Organizacija: FS - Fakulteta za strojništvo
• Status publikacije: Objavljeno
• Različica publikacije: Objavljena publikacija
• Leto izida: 2020
• Št. strani: 17 str.
• Številčenje: Vol. 10, iss. 4, art. 542
• PID: 20.500.12556/RUL-133717
• UDK: 621.713.3:004.942(045)
• ISSN pri članku: 2075-4701
• DOI: 10.3390/met10040542
• COBISS.SI-ID: 17170459
• Datum objave v RUL: 10.12.2021

Gradivo je del revije

• Naslov: Metals
• Skrajšan naslov: Metals
• Založnik: MDPI AG
• ISSN: 2075-4701
• COBISS.SI-ID: 15976214

Licence

• Licenca: CC BY 4.0, Creative Commons Priznanje avtorstva 4.0 Mednarodna
• Povezava: http://creativecommons.org/licenses/by/4.0/deed.sl
• Opis: To je standardna licenca Creative Commons, ki daje uporabnikom največ možnosti za nadaljnjo uporabo dela, pri čemer morajo navesti avtorja.
• Začetek licenciranja: 22.04.2020

Sekundarni jezik

• Jezik: Slovenski jezik
• Ključne besede: plastičnost, numerične simulacije, identifikacija, dvoosno preizkušanje

Projekti

• Financer: ARRS - Agencija za raziskovalno dejavnost Republike Slovenije
• Številka projekta: P2-0263
• Naslov: Mehanika v tehniki